ST7540 datasheet(25/44 Pages) STMICROELECTRONICS

25 / 44 page

ST7540

Functional description

25/44

●

Carrier Detection

The Carrier/Preamble detection Block notifies to the host controller the presence of a

Carrier when it detects on the RX_IN Input a signal with an harmonic component close

to the programmed Carrier Frequency. The CD_PD signal sensitivity is identical to the

data reception sensitivity (0.5mVrms Typ. in Normal Sensitivity Mode). When the

device sensitivity is set by the TxD line (Sensitivity level equal to BU threshold) the

CD_PD signal is conditioned to the BU signal.

The CD_PD line is forced to a logic level low when a Carrier is detected.

●

Preamble Detection

The Carrier/Preamble detection Block notifies to the host controller the presence of a

Carrier modulated at the Programmed Baud Rate for at least 4 Consecutive Symbols

(“1010” or “0101” are the symbols sequences detected).

CD_PD line is forced low till a Carrier signal is detected and PLL is in the lock-in range.

To reinforce the effectiveness of the information given by CD_PD Block, a digital

filtering is applied on Carrier or Preamble notification signal (see Section 6.8: Control

Increasing the Detection Time reduced the false notifications caused by noise on main

line. The Digital filter adds a delay to CD_PD notification equal to the programmed

Detection Time. When the carrier frequency disappears, CD_PD line is held low for a

period equal to the detection time and then forced high. During this time, some

spurious data caused by noise can be demodulated and sent over RxD line.

●

Header Recognition

In Control Register Extended Mode (Control Register bit 21=”1”, see Table 12) the

CD_PD line can be used to recognize if an header has been sent during the

transmission. With Header Recognition function enable (Control Register bit 18=”1”,

see Table 12), CD_PD line is forced low when a Frame Header is detected. If Frame

Length Count function is enabled, CD_PD is held low and a number of 16 bit word

equal to the Frame Length selected is sent to the host controller. In this case, CLR/T is

forced to “0” and RxD is forced to “0” or “1” (according the UART/SPI pin level) when

Header has not been detected or after the Frame Length has been reached.

If Frame Length Count function is disabled, an header recognition is signaled by forcing

CD_PD low for one period of CLR/T line. In this case, CLR/T and RxD signal are

always present, even if no header has been recognized.

ST7540 数据表(PDF) 25 Page - STMicroelectronics

ST7540 数据表(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载