ADL5960ACCZ-R2 datasheet(6/32 Pages) AD

6 / 32 page

Data Sheet

ADL5960

ABSOLUTE MAXIMUM RATINGS

analog.com

Rev. A | 6 of 32

Table 3. Absolute Maximum Ratings

Parameter

Rating

Supply Voltage (AVCC and OVCC)

5.5 V

RFIN, RFOUT Input AC Power

Average1

30 dBm

Peak1

35 dBm

DC Voltage

RFIN, RFOUT to AGND1

−5 V to +10 V

OVDD

−0.3 V to +3.8 V

SCK, CS, and SDIO

−0.3 V to OVDD + 0.3 V

IFFP, IFFM, IFRP, IFRM2

−0.3 V to OVCC + 0.3 V

Any Other Pin3

−0.3 V to AVCC + 0.3 V

DC Current RFIN to or from RFOUT

100 mA

Temperature

Maximum TJ

150°C

TA Operating Range

−40°C to +105°C

Storage Range

−65°C to +150°C

1 Not production tested. Guaranteed by design and correlation to production

tested parameters. Peak power duty cycle is 10% maximum.

2 The voltage on these pins must not exceed 5.5 V, OVCC + 0.3 V, or be less

than –0.3 V.

3 The voltage on these pins must not exceed 5.5 V, AVCC + 0.3 V, or be less

than –0.3 V.

Stresses at or above those listed under Absolute Maximum Ratings

may cause permanent damage to the product. This is a stress

rating only; functional operation of the product at these or any other

conditions above those indicated in the operational section of this

specification is not implied. Operation beyond the maximum operat-

ing conditions for extended periods may affect product reliability.

THERMAL RESISTANCE

Thermal performance is directly linked to PCB design and operating

environment. Careful attention to PCB thermal design is required.

θJA is the junction to ambient (or die to ambient) thermal resistance

measured in a one cubic foot sealed enclosure, and θJC is the

junction to case (or die to package) thermal resistance.

Table 4. Thermal Resistance

Package

Type1

θJA

θJB2

θJCT3

θJCB4

ΨJT

ΨJB

Unit

CC-26-2

39.32

13.10

30.09

7.63

1.30

12.95

°C/W

1 Test Condition 1: thermal impedance simulated values are based upon use of

2S2P JEDEC PCB. See the Ordering Guide.

2 θJB is the junction-to-board thermal resistance.

3 θJCT is the junction-to-case top thermal resistance.

4 θJCB is the junction-to-case bottom thermal resistance.

ESD CAUTION

ESD (electrostatic discharge) sensitive device. Charged devi-

ces and circuit boards can discharge without detection. Although

this product features patented or proprietary protection circuitry,

damage may occur on devices subjected to high energy ESD.

Therefore, proper ESD precautions should be taken to avoid

performance degradation or loss of functionality.

ADL5960ACCZ-R2 数据表(PDF) 6 Page - Analog Devices

ADL5960ACCZ-R2 数据表(HTML) 6 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载