| 数据搜索系统,热门电子元器件搜索 |
|
WM8731SEDS/R 数据表(PDF) 44 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8731SEDS/R 数据表(HTML) 44 Page - Wolfson Microelectronics plc |
|
44 / 63 page ![]() WM8731 / WM8731L Production Data w PD Rev 4.3 August 2006 44 the data across the digital interface is correctly synchronised at the 8.021kHz and 44.117kHz rates. The exact sample rates supported for all combinations are defined by the relationships in Table 22 below. ACTUAL SAMPLING RATE TARGET SAMPLING RATE BOSR=0 ( 250fs) BOSR=1 (272fs) kHz kHz kHz 8 8.021 8 12MHz/(250 x 48/8) 12MHz/(272 x 11/2) 32 32 12MHz/(250 x 48/32) not available 44.117 44.1 not available 12MHz/272 48 48 12MHz/250 not available 88.235 88.2 not available 12MHz/136 96 96 12MHz/125 not available Table 22 USB Mode Actual Sample Rates ACTIVATING DSP AND DIGITAL AUDIO INTERFACE To prevent any communication problems from arising across the Digital Audio Interface the Audio Interface is disabled (tristate with weak 100k pulldown). Once the Audio Interface and the Sampling Control has been programmed it is activated by setting the ACTIVE bit under Software Control. REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION 0001001 Active Control 0 ACTIVE 0 Activate Interface 1 = Active 0 = Inactive Table 23 Activating DSP and Digital Audio Interface It is recommended that between changing any content of Digital Audio Interface or Sampling Control Register that the active bit is reset then set. SOFTWARE CONTROL INTERFACE The software control interface may be operated using either a 3-wire (SPI-compatible) or 2-wire MPU interface. Selection of interface format is achieved by setting the state of the MODE pin. In 3-wire mode, SDIN is used for the program data, SCLK is used to clock in the program data and CSB is used to latch in the program data. In 2-wire mode, SDIN is used for serial data and SCLK is used for the serial clock. In 2-wire mode, the state of CSB pin allows the user to select one of two addresses. SELECTION OF SERIAL CONTROL MODE The serial control interface may be selected to operate in either 2 or 3-wire modes. This is achieved by setting the state of the MODE pin. MODE INTERFACE FORMAT 0 2 wire 1 3 wire Table 24 Control Interface Mode Selection |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |