ICS1893CFILF datasheet(59/126 Pages) ICST

59 / 126 page

Chapter 7 Management Register Set

ICS1893CF, Rev. F, 03/01/07

Mar. 2007

ICS1893CF Data Sheet Rev. F - Release

7.6.2 IEEE Reserved Bit (bit 4.14)

The ISO/IEC specification reserves this bit for future use. However, the ISO/IEC Standard also defines bit

4.14 as the Acknowledge bit.

When this reserved bit is read by an STA, the ICS1893CF returns a logic zero. However, whenever an STA

writes to this reserved bit, it must use the default value specified in this data sheet. ICS uses some reserved

bits to invoke auxiliary functions. To ensure proper operation of the ICS1893CF, an STA must maintain the

default value of these bits. Therefore, ICS recommends that an STA always write the default value of any

reserved bits during all management register write operations.

Reserved bit 4.14 is a Command Override Write (CW) bit. Whenever bit 16.15 (the Command Register

Override bit) is logic:

• Zero, the ICS1893CF isolates all STA writes to bit 4.14.

• One, an STA can modify the value of bit 4.14.

7.6.3 Remote Fault (bit 4.13)

When the ICS1893CF Auto-Negotiation sublayer is enabled, the ICS1893CF transmits the Remote Fault bit

4.13 to its remote link partner during the auto-negotiation process. The Remote Fault bit is part of the Link

Code Word that the ICS1893CF exchanges with its remote link partner. The ICS1893CF sets this bit to logic

one whenever it detects a problem with the link, locally. The data in this register is sent to the remote link

partner to inform it of the potential problem. If the ICS1893CF does not detect a link fault, it clears bit 4.13

to logic zero.

Whenever the ICS1893CF:

• Does not detect a link fault, the ICS1893CF clears bit 4.13 to logic zero.

• Detects a problem with the link, during the auto-negotiation process, this bit is set. As a result, the data

on this bit is sent to the remote link partner to inform it of the potential problem.

7.6.4 IEEE Reserved Bits (bits 4.12:10)

The IEEE reserves these bits for future use. When an STA:

• Reads a reserved bit, the ICS1893CF returns a logic zero.

• Writes to a reserved bit, it must use the default value specified in this data sheet.

The ICS1893CF uses some reserved bits to invoke auxiliary functions. To ensure proper operation of the

ICS1893CF, an STA must maintain the default value of these bits. Therefore, ICS recommends that during

any STA write operation, an STA write the default value to all reserved bits, even those bits that are Read

Only.

ICS1893CFILF 数据表(PDF) 59 Page - Integrated Circuit Systems

ICS1893CFILF 数据表(HTML) 59 Page - Integrated Circuit Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载