| 数据搜索系统,热门电子元器件搜索 |
|
LP3950SL 数据表(PDF) 16 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
LP3950SL 数据表(HTML) 16 Page - National Semiconductor (TI) |
|
16 / 31 page ![]() Boost Converter Typical Performance Characteristics V IN = 3.6V, VOUT = 5.0V if not otherwise stated. (Continued) Boost Line Regulation Boost Load Transient Response, 50 mA to 100 mA 20129319 20129323 RGB LED Pattern Generator The LP3950 RGB outputs can be controlled either with audio synchronization or with RGB pattern generator. The pattern generator of LP3950 drives three independently controlled LED outputs (for example, R1, G1 and B1). The functionality is similar compared to RGB functionality of LP3936 and LP3933. The output of RGB pattern generator can be selected to drive RGB1 (R1-G1-B1), RGB2 (R2-G2-B2) or RGB1 and RGB2 (R1&R2 – G1&G2 – B1&B2) outputs. Programmable Pattern Mode User has control over the following parameters separately for each LED: • ON and OFF (start and stop time in blinking cycle) • DUTY (PWM brightness control) • SLOPE (dimming slope) • ENABLE (output enable control) The main blinking cycle is controlled with three-bit CYCLE control (0.25 / 0.5 / 1.0 / 2.0 / 4.0s). RGB_START is the master control for the whole RGB func- tion. The internal PWM and blinking control can be disabled by setting the RGB_PWM control LOW. In this case the individual enable controls can be used to switch outputs on and off. PWM_EN input can be used for external hardware PWM control. In the normal PWM mode the R, G and B switches are controlled in 3 phases (one phase per driver). During each phase the peak current set by an external ballast resistor is driven through the LED for the time defined by DUTY setting (0 µs to 50 µs). As a time averaged current this means 0% to 33% of the peak current. The PWM period is 150 µs and the pulse frequency is 6.67 kHz in normal mode. In the FLASH mode all the outputs are controlled in one phase and the PWM period is 50 µs. The time averaged FLASH mode current is three times the normal mode current at the same DUTY value. 20129324 FIGURE 12. RGB PWM Operating Principle 20129325 FIGURE 13. Normal Mode PWM Waveforms at Different Duty Settings www.national.com 16 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |