M50FW080 datasheet(28/56 Pages) STMICROELECTRONICS

28 / 56 page

Status Register

M50FW080

28/55

Status Register

The Status Register provides information on the current or previous Program or Erase

operation. Different bits in the Status Register convey different information and errors on the

operation.

To read the Status Register the Read Status Register command can be issued. The Status

commands are issued. The Status Register can be read from any address.

The Status Register bits are summarized in Table 10. The following text descriptions should

be read in conjunction with Table 10.

5.1

Program/Erase Controller status (bit 7)

The Program/Erase Controller Status bit indicates whether the Program/Erase Controller is

active or inactive. When the Program/Erase Controller Status bit is ‘0’, the Program/Erase

Controller is active; when the bit is ‘1’, the Program/Erase Controller is inactive.

The Program/Erase Controller Status is ‘0’ immediately after a Program/Erase Suspend

command is issued until the Program/Erase Controller pauses. After the Program/Erase

Controller pauses the bit is ‘1’.

During Program and Erase operation the Program/Erase Controller Status bit can be polled

to find the end of the operation. The other bits in the Status Register should not be tested

until the Program/Erase Controller completes the operation and the bit is ‘1’.

After the Program/Erase Controller completes its operation the Erase Status, Program

Status, VPP Status and Block Protection Status bits should be tested for errors.

5.2

Erase Suspend status (bit 6)

The Erase Suspend Status bit indicates that a Block Erase operation has been suspended

and is waiting to be resumed. The Erase Suspend Status should only be considered valid

when the Program/Erase Controller Status bit is ‘1’ (Program/Erase Controller inactive);

after a Program/Erase Suspend command is issued the memory may still complete the

operation rather than entering the Suspend mode.

When the Erase Suspend Status bit is ‘0’ the Program/Erase Controller is active or has

completed its operation; when the bit is ‘1’ a Program/Erase Suspend command has been

issued and the memory is waiting for a Program/Erase Resume command.

When a Program/Erase Resume command is issued the Erase Suspend Status bit returns

to ‘0’.

M50FW080 数据表(PDF) 28 Page - STMicroelectronics

M50FW080 数据表(HTML) 28 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载