ST62T35B datasheet(12/82 Pages) STMICROELECTRONICS

12 / 82 page

12/82

ST62T35B/E35B

MEMORY MAP (Cont’d)

1.3.6

Data

RAM/EEPROM

Bank

(DRBR)

Address: CBh

—

Write only

Bit 7-5 = These bits are not used

Bit 4 - DRBR4. This bit, when set, selects RAM

Page 2.

Bit 3 - DRBR3. This bit, when set, selects RAM

Page 1.

Bit2. This bit is not used.

Bit 1 - DRBR1. This bit, when set, selects

EEPROM Page 1.

Bit 0 - DRBR0. This bit, when set, selects

EEPROM Page 0.

The selection of the bank is made by program-

ming the Data RAM Bank Switch register (DRBR

Space according to Table 1. No more than one

bank should be set at a time.

The DRBR register can be addressed like a RAM

Data Space at the address CBh; nevertheless it is

a write only register that cannot be accessed with

single-bit operations. This register is used to se-

lect the desired 64-byte RAM/EEPROM bank of

the Data Space. The number of banks has to be

loaded in the DRBR register and the instruction

has to point to the selected location as if it was in

bank 0 (from 00h address to 3Fh address).

This register is not cleared during the MCU initial-

ization, therefore it must be written before the first

access to the Data Space bank region. Refer to

the Data Space description for additional informa-

tion. The DRBR register is not modified when an

interrupt or a subroutine occurs.

Notes :

Care is required when handling the DRBR register

as it is write only. For this reason, it is not allowed

to change the DRBR contents while executing in-

terrupt service routine, as the service routine can-

not save and then restore its previous content. If it

is impossible to avoid the writing of this register in

interrupt service routine, an image of this register

must be saved in a RAM location, and each time

the program writes to DRBR it must write also to

the image register. The image register must be

written first, so if an interrupt occurs between the

two instructions the DRBR is not affected.

In DRBR Register, only 1 bit must be set. Other-

wise two or more pages are enabled in parallel,

producing errors.

Table 5. Data RAM Bank Register Set-up

DRBR4 DRBR3

DRBR1 DRBR0

DRBR

ST62T35B

None

EEPROM Page 0

EEPROM Page 1

RAM Page 1

10h

RAM Page 2

other

Reserved

ST62T35B 数据表(PDF) 12 Page - STMicroelectronics

ST62T35B 数据表(HTML) 12 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

数据表下载