AT25DF161 datasheet(18/60 Pages) ATMEL

18 / 60 page

3687C–DFLASH–7/09

AT25DF161 [Preliminary]

operation is not allowed to a sector that has been program suspended. If attempted, the erase

operation will abort and the WEL bit in the Status Register will be reset to a logical “0” state.

During an Erase Suspend, a program operation to a different 64-Kbyte sector can be started and

subsequently suspended. This results in a simultaneous Erase Suspend/Program Suspend con-

dition and will be indicated by the states of both the ES and PS bits in the Status Register being

set to the logical “1” state.

If a Reset operation (see “Reset” on page 42) is performed while a sector is erase suspended,

the suspend operation will abort and the contents of the block in the suspended sector will be left

in an undefined state. However, if a Reset is performed while a sector is program suspended,

the suspend operation will abort but only the contents of the page that was being programmed

and subsequently suspended will be undefined. The remaining pages in the 64-Kbyte sector will

retain their previous contents.

If an attempt is made to perform an operation that is not allowed during a program or erase sus-

pend, such as a Protect Sector operation, then the device will simply ignore the opcode and no

operation will be performed. The state of the WEL bit in the Status Register, as well as the SPRL

(Sector Protection Registers Locked) and SLE (Sector Lockdown Enabled) bits, will not be

affected.

AT25DF161 数据表(PDF) 18 Page - ATMEL Corporation