AT25DF161 datasheet(40/60 Pages) ATMEL

40 / 60 page

3687C–DFLASH–7/09

AT25DF161 [Preliminary]

11.2 Write Status Register Byte 1

The Write Status Register Byte 1 command is used to modify the SPRL bit of the Status Regis-

ter and/or to perform a Global Protect or Global Unprotect operation. Before the Write Status

ously issued to set the WEL bit in the Status Register to a logical “1”.

To issue the Write Status Register Byte 1 command, the CS pin must first be asserted and the

opcode of 01h must be clocked into the device followed by one byte of data. The one byte of

data consists of the SPRL bit value, a don’t care bit, four data bits to denote whether a Global

Protect or Unprotect should be performed, and two additional don’t care bits (see Table 11-3).

Any additional data bytes that are sent to the device will be ignored. When the CS pin is deas-

serted, the SPRL bit in the Status Register will be modified, and the WEL bit in the Status

SPRL bit before the Write Status Register Byte 1 command was executed (the prior state of the

SPRL bit) will determine whether or not a Global Protect or Global Unprotect will be performed.

Please refer to “Global Protect/Unprotect” on page 24 for more details.

The complete one byte of data must be clocked into the device before the CS pin is deasserted,

and the CS pin must be deasserted on even byte boundaries (multiples of eight bits); otherwise,

the device will abort the operation, the state of the SPRL bit will not change, no potential Global

Protect or Unprotect will be performed, and the WEL bit in the Status Register will be reset back

to the logical “0” state.

If the WP pin is asserted, then the SPRL bit can only be set to a logical “1”. If an attempt is made

to reset the SPRL bit to a logical “0” while the WP pin is asserted, then the Write Status Register

Byte 1 command will be ignored, and the WEL bit in the Status Register will be reset back to the

logical “0” state. In order to reset the SPRL bit to a logical “0”, the WP pin must be deasserted.

Figure 11-2. Write Status Register Byte 1

Table 11-3.

Write Status Register Byte 1 Format

Bit 7Bit 6Bit 5Bit 4Bit 3Bit 2Bit 1Bit 0

SPRL

Global Protect/Unprotect

SCK

MSB

0000000

OPCODE

10 11

814 15

MSB

DXD

STATUS REGISTER IN

BYTE 1

HIGH-IMPEDANCE

AT25DF161 数据表(PDF) 40 Page - ATMEL Corporation

AT25DF161 数据表(HTML) 40 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

数据表下载