ATtiny10 datasheet(73/168 Pages) ATMEL

73 / 168 page

8127C–AVR–10/09

ATtiny4/5/9/10

Note:

See “Code Examples” on page 5.

The code example requires that the r17:r16 register pair contains the value to be written to

TCNT0.

11.10.1

Reusing the Temporary High Byte Register

If writing to more than one 16-bit register where the high byte is the same for all registers written,

then the high byte only needs to be written once. However, note that the same rule of atomic

operation described previously also applies in this case.

11.11 Register Description

11.11.1

TCCR0A – Timer/Counter0 Control Register A

• Bits 7:6 – COM0A1:0: Compare Output Mode for Channel A

• Bits 5:4 – COM0B1:0: Compare Output Mode for Channel B

The COM0A1:0 and COM0B1:0 control the behaviour of Output Compare pins OC0A and

OC0B, respectively. If one or both COM0A1:0 bits are written to one, the OC0A output overrides

the normal port functionality of the I/O pin it is connected to. Similarly, if one or both COM0B1:0

bit are written to one, the OC0B output overrides the normal port functionality of the I/O pin it is

connected to.

Note, however, that the Data Direction Register (DDR) bit corresponding to the OC0A or OC0B

pin must be set in order to enable the output driver.

Assembly Code Example

TIM16_WriteTCNT

; Save global interrupt flag

r18,SREG

; Disable interrupts

cli

; Set TCNT

0 to r17:r16

out

TCNT

0H,r17

out

TCNT

0L,r16

; Restore global interrupt flag

out

SREG,r18

ret

Bit

0x2E

COM0A1

COM0A0

COM0B1

COM0B0

–

WGM01

WGM00

TCCR0A

Read/Write

R/W

Initial Value

ATtiny10 数据表(PDF) 73 Page - ATMEL Corporation

ATtiny10 数据表(HTML) 73 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载