ATtiny10 datasheet(54/168 Pages) ATMEL

54 / 168 page

8127C–AVR–10/09

ATtiny4/5/9/10

11.3 Clock Sources

The Timer/Counter can be clocked by an internal or an external clock source. The clock source

is selected by the Clock Select logic which is controlled by the Clock Select (CS02:0) bits

located in the Timer/Counter control Register B (TCCR0B). For details on clock sources and

prescaler, see section “Prescaler”.

11.3.1

Prescaler

The Timer/Counter can be clocked directly by the system clock (by setting the CS2:0 = 1). This

provides the fastest operation, with a maximum Timer/Counter clock frequency equal to system

clock frequency (fCLK_I/O). Alternatively, one of four taps from the prescaler can be used as a

clock source.

See Figure 11-2 for an illustration of the prescaler unit.

Figure 11-2. Prescaler for Timer/Counter0

Note:

1. The synchronization logic on the input pins (

T0) is shown in Figure 11-3 on page 55.

The prescaled clock has a frequency of fCLK_I/O/8, fCLK_I/O/64, fCLK_I/O/256, or fCLK_I/O/1024. See

Table 11-6 on page 76 for details.

11.3.1.1

Prescaler Reset

The prescaler is free running, i.e., operates independently of the Clock Select logic of the

Timer/CounterCounter, and it is shared by the Timer/Counter Tn. Since the prescaler is not

affected by the Timer/Counter’s clock select, the state of the prescaler will have implications for

situations where a prescaled clock is used. One example of prescaling artifacts occurs when the

timer is enabled and clocked by the prescaler (CS2:0 = 2, 3, 4, or 5). The number of system

PSR10

Clear

clk

I/O

Synchronization

ATtiny10 数据表(PDF) 54 Page - ATMEL Corporation