TNETX3110 datasheet(19/65 Pages) TI1

19 / 65 page

TNETX3110

ThunderSWITCH

™ 8/3 ETHERNET™ SWITCH

WITH 8 10-MBIT/S PORTS AND 3 10-/100-MBIT/S PORTS

SPWS047A – MARCH 1998 – REVISED APRIL 1999

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

network management port

Frames are received or transmitted via the DIO interface using a built-in port, the network management (NM)

port.

Frames originating within the host are written to this port via the NMRxcontrol and NMdata registers. Once a

frame has been fully written, it is received by the switch and routed to the destination port(s).

Frames that were routed to this port from any of the switch’s ports queue until the host is ready to read them

via the NMTxcontrol and NMdata registers. They are then effectively transmitted out of the switch.

IEEE Std 802.1Q VLAN headers on the NM port

Frames received from the host via the NM port are required to contain a valid IEEE Std 802.1Q header. Frames

that do not contain a valid header are incorrectly routed. They may be corrupted at the transmission port(s), as

the header-stripping process does not verify that the four bytes after the source address are actually a valid

header because they always are a valid header under all other circumstances.

When a frame is transmitted to the NM port, no header-stripping occurs, so the frame contains one, or possibly

two headers, depending on how the frame was originally received.

full-duplex NM port

The NM port can intermix reception and transmission as desired. The direction of the NMdata access (i.e., read

or write) determines whether a byte is removed from the transmit queue or added to the receive queue. The

DIO interface is half duplex since it can do only a read or write at one time.

NM bandwidth and priority

The NM port is capable of transferring a byte to or from NMdata once every five cycles, so the burst rate of this

port approximates eight bits per 60 ns (or

≈133 Mbit/s). This can be sustained between the DIO port and the

NM port’s dedicated transmit or receive buffers.

However, the NM port is prioritized lower than the other ports between its receive and transmit buffers and the

external memory system so that, at periods of high activity, the NM port does not cause frames to be dropped

on the other ports. STXRDY and SRXRDY, the interrupts and freebuffs, eof, sof, and iof mechanisms can be

used as desired to prevent unwanted stalls on the DIO bus during busy periods.

The burst rate is unaffected by traffic on other ports.

interrupt processing

There are two interrupts available on the NM port.

The interrupt process uses RXRDY and the nmrx interrupts to indicate when the receive FIFO is empty. This

indicates that the NM port is ready to accept a frame of any length (up to 1536 bytes).

If the host needs to download a sequence of frames, it can use the freebuffs field to indicate space availability.

TNETX3110 数据表(PDF) 19 Page - Texas Instruments

TNETX3110 数据表(HTML) 19 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

数据表下载