STM8S207MB datasheet(96/103 Pages) STMICROELECTRONICS

96 / 103 page

Package characteristics

STM8S207xx, STM8S208xx

96/103

Doc ID 14733 Rev 12

11.2.2

Selecting the product temperature range

When ordering the microcontroller, the temperature range is specified in the order code (see

Figure 49: STM8S207xx/208xx performance line ordering information scheme(1) on

page 99).

The following example shows how to calculate the temperature range needed for a given

application.

Assuming the following application conditions:

●

Maximum ambient temperature TAmax= 82 °C (measured according to JESD51-2)

●

IDDmax = 15 mA, VDD = 5.5 V

●

Maximum eight standard I/Os used at the same time in output at low level with IOL = 10

mA, VOL= 2 V

●

Maximum four high sink I/Os used at the same time in output at low level with IOL = 20

mA, VOL= 1.5 V

●

Maximum two true open drain I/Os used at the same time in output at low level with

IOL = 20 mA, VOL= 2 V

PINTmax = 15 mA x 5.5 V = 82.5 mW

PIOmax = (10 mA x 2 V x 8 ) + (20 mA x 2 V x 2) + (20 mA x 1.5 V x 4) = 360 mW

This gives: PINTmax = 82.5 mW and PIOmax 360 mW:

PDmax = 82.5 mW + 360 mW

Thus: PDmax = 443 mW

Using the values obtained in Table 57: Thermal characteristics on page 95 TJmax is

calculated as follows for LQFP64 10 x 10 mm = 46 °C/W:

TJmax = 82 °C + (46 °C/W x 443 mW) = 82 °C + 20 °C = 102 °C

This is within the range of the suffix 6 version parts (-40 < TJ < 105 °C).

In this case, parts must be ordered at least with the temperature range suffix 6.

STM8S207MB 数据表(PDF) 96 Page - STMicroelectronics

STM8S207MB 数据表(HTML) 96 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载