STA382BW datasheet(86/172 Pages) STMICROELECTRONICS

86 / 172 page

STA382BW

86/172

Doc ID 022783 Rev 1

6.25

Fault-detect recovery constant registers (addr 0x3C - 0x3D)

The FDRC bits specify the 16-bit fault-detect recovery time delay. When FAULT is asserted,

the TRISTATE output is immediately asserted low and held low for the time period specified

by this constant. A constant value of 0x0001 in this register is approximately 0.083 ms. The

default value of 0x300C gives approximately 1 sec.

0x0000 is a reserved value.

6.26

Extended configuration register (addr 0x47)

The extended configuration register provides access to biquad 5, 6 and 7.

6.26.1

Extended post-scale range

Table 75.

Extended post-scale range

Post-scale is an attenuation by default. When PS48DB is set to 1, a 48-dB offset is applied

to the coefficient RAM value, so post-scale can act as a gain too.

6.26.2

Extended attack rate

The attack rate shown in Table 68 can be extended to provide up to an 8 dB/ms attack rate

on both limiters.

Table 76.

Extended attack rate, limiter 1

FDRC15

FDRC14

FDRC13

FDRC12

FDRC11

FDRC10

FDRC9

FDRC8

FDRC7

FDRC6

FDRC5

FDRC4

FDRC3

FDRC2

FDRC1

FDRC0

Reserved

PS48DB

XAR1

XAR2

BQ5

BQ6

BQ7

111

PS48DB

Mode

Post-scale value is applied as defined in the coefficient RAM

Post-scale value is applied with a +48 dB offset with respect to the

coefficient RAM value

XAR1

Mode

Limiter1 attack rate is configured using Table 68

Limiter1 attack rate is 8 dB/ms

STA382BW 数据表(PDF) 86 Page - STMicroelectronics

STA382BW 数据表(HTML) 86 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载