| 数据搜索系统,热门电子元器件搜索 |
|
MAS6502 数据表(PDF) 8 Page - Micro Analog systems |
|
|
|||||||||||||||||||||||||||||
MAS6502 数据表(HTML) 8 Page - Micro Analog systems |
|
8 / 20 page ![]() DA6502.008 29 November 2012 8 (20) ADC CONTROL REGISTER Table 2. MAS6502 ADC control register bit description Bit Number Bit Name Description Value Function 7-6 OSRS Over Sampling Ratio (OSR) selection 11 01 10 00 OSR = 512 OSR = 256 OSR = 128 OSR = 64 5 PTS Pressure/Temperature Selection 1 0 Pressure Measurement Temperature Measurement 4-3 ISR Input Signal Range 11 10 01 00 325 mV (260 mV linear range) 220 mV (176 mV linear range) 150 mV (120 mV linear range) 100 mV (80 mV linear range) 2 OSSELECT Offset Selection 1 0 +33 mV No offset 1-0 RSSELECT Sensor Resistance Selection for Temperature Measurement Mode 11 10 01 00 Rsensor = 3.4 kΩ Rsensor = 4.0 kΩ Rsensor = 4.5 kΩ Rsensor = 5.0 kΩ MAS6502 has an ADC control register for configuring the measurement setup. A new conversion is started simply by writing 8-bit configuration data to the ADC control register. See table 2 for ADC control register bit definitions. ADC control register values are set via the 2-wire serial data interface. Note: The device should not be addressed via serial bus before the conversion has been ended. Reading or writing to device during the conversion may corrupt the conversion result. The first two OSRS bits of the control register defines four selectable over sampling ratios. The higher the OSR is set the better is the ADC resolution, but the conversion time gets longer. The PTS bit selects between pressure and temperature measurement. For temperature measurement the sensor is connected in the Wheatstone bridge configuration together with four integrated resistors. See figure 5 on page 15. The ISR bits selects between four A/D input signal ranges. The OSSELECT bit is used to enable or disable an offset for the input signal. The two RSSELECT bits selects between four sensor resistance options. The selection sets the internal R3 resistor value to balance the Wheatstone bridge circuit formed by the sensor resistance and four internal resistors R1, R2, R3 and R4. See Electrical Characteristics for resistor values. |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |