LSM330DLC datasheet(35/66 Pages) STMICROELECTRONICS

35 / 66 page

LSM330DLC

Digital interfaces

Doc ID 022162 Rev 2

35/66

6.2

SPI bus interface

The LSM330DLC SPI is a bus slave. The SPI allows writing and reading the registers of the

device.

The serial interface interacts with the outside world through 4 wires: CS, SPC, SDI and SDO

(SPC, SDI, SD0 are common).

Figure 14.

Read and write protocol

CS is the serial port enable and is controlled by the SPI master. It goes low at the start of the

transmission and returns high at the end. SPC is the serial port clock and is controlled by

the SPI master. It is stopped high when CS is high (no transmission). SDI and SDO are

respectively the serial port data input and output. These lines are driven at the falling edge

of SPC and should be captured at the rising edge of SPC.

Both the read register and write register commands are completed in 16 clock pulses or in

multiples of 8 in case of multiple-byte read/write. Bit duration is the time between two falling

edges of SPC. The first bit (bit 0) starts at the first falling edge of SPC after the falling edge

of CS, while the last bit (bit 15, bit 23, ...) starts at the last falling edge of SPC just before the

rising edge of CS.

bit 0: RW bit. When 0, the data DI(7:0) is written to the device. When 1, the data DO(7:0)

from the device is read. In the latter case, the chip drives SDO at the start of bit 8.

bit 1: MS bit. When 0, the address remains unchanged in multiple read/write commands.

When 1, the address is auto-incremented in multiple read/write commands.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (Write mode). This is the data that will be written to the device (MSb

first).

bit 8-15: data DO(7:0) (Read mode). This is the data that will be read from the device (MSb

first).

In multiple read/write commands, further blocks of 8 clock periods will be added. When the

MS bit is ‘0’, the address used to read/write data remains the same for every block. When

the MS bit is ‘1’, the address used to read/write data is increased at every block.

The function and the behavior of SDI and SDO remain unchanged.

SPC

SDI

SDO

AD5 AD4 AD3 AD2 AD1 AD0

DI7 DI6 DI5 DI4 DI3 DI2 DI1 DI0

DO7 DO6 DO5 DO4 DO3 DO2 DO1 DO0

AM10129V1

LSM330DLC 数据表(PDF) 35 Page - STMicroelectronics

LSM330DLC 数据表(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

数据表下载