PIC16LC773 datasheet(95/200 Pages) MICROCHIP

95 / 200 page

PIC16C77X

Advance Information

DS30275A-page 95

8.3

Connection Considerations for I2C

Bus

For standard-mode I2C bus devices, the values of

resistors

Rp Rs in Figure 8-42 depends on the following

parameters

• Supply voltage

• Bus capacitance

• Number of connected devices

(input current + leakage current).

The supply voltage limits the minimum value of resistor

Rp due to the specified minimum sink current of 3 mA

at VOL max = 0.4V for the specified output stages. For

example, with a supply voltage of VDD = 5V+10% and

VOL max = 0.4V at 3 mA, Rp min = (5.5-0.4)/0.003 =

1.7 k

Ω. VDD as a function of R

p is shown in Figure 8-42.

The desired noise margin of 0.1VDD for the low level

limits the maximum value of

Rs. Series resistors are

optional and used to improve ESD susceptibility.

The bus capacitance is the total capacitance of wire,

connections, and pins. This capacitance limits the max-

imum value of

Rp due to the specified rise time

(Figure 8-42).

The SMP bit is the slew rate control enabled bit. This bit

is in the SSPSTAT register, and controls the slew rate

of the I/O pins when in I2C mode (master or slave).

FIGURE 8-42: SAMPLE DEVICE CONFIGURATION FOR I2C BUS

VDD + 10%

SDA

SCL

NOTE: I2C devices with input levels related to VDD must have one common supply

line to which the pull up resistor is also connected.

DEVICE

Cb=10 - 400 pF

PIC16LC773 数据表(PDF) 95 Page - Microchip Technology

PIC16LC773 数据表(HTML) 95 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载