A25LS512A datasheet(12/43 Pages) AMICC

12 / 43 page

A25LS512A Series

(November, 2014, Version 1.1)

AMIC Technology Corp.

Read Status Register (RDSR)

The Read Status Register (RDSR) instruction allows the

Status Register to be read. The Status Register may be read

at any time, even while a Program, Erase or Write Status

progress, it is recommended to check the Write In Progress

(WIP) bit before sending a new instruction to the device. It is

also possible to read the Status Register continuously, as

shown in Figure 6.

Table 4. Status Register Format

SRWD

BP2

BP1

BP0 WEL WIP

Status Register

Write Protect

Block Protect Bits

Write Enable Latch Bit

Write In Progress Bit

The status and control bits of the Status Register are as

follows:

WIP bit.

The Write In Progress (WIP) bit indicates whether

the memory is busy with a Write Status Register, Program or

Erase cycle. When set to 1, such a cycle is in progress, when

reset to 0 no such cycle is in progress.

WEL bit.

The Write Enable Latch (WEL) bit indicates the

status of the internal Write Enable Latch. When set to 1 the

internal Write Enable Latch is set, when set to 0 the internal

Write Enable Latch is reset and no Write Status Register,

Program or Erase instruction is accepted.

BP2, BP1, BP0 bits.

The Block Protect (BP2, BP1, BP0) bits

are non-volatile. They define the size of the area to be

software protected against Program and Erase instructions.

These bits are written with the Write Status Register (WRSR)

instruction. When one or more of the Block Protect (BP2,

BP1, BP0) bits is set to 1, the relevant memory area (as

defined in Table 1.) becomes protected against Page

Program (PP), Sector Erase (SE), and Block Erase (BE)

instructions. The Block Protect (BP2, BP1, BP0) bits can be

written provided that the Hardware Protected mode has not

been set. The Chip Erase (CE) instruction is executed if, and

only if, all Block Protect (BP2, BP1, BP0) bits are 0.

SRWD bit.

The Status Register Write Disable (SRWD) bit is

operated in conjunction with the Write Protect (

W ) signal.

The Status Register Write Disable (SRWD) bit and Write

Protect (

W ) signal allow the device to be put in the

Hardware Protected mode (when the Status Register Write

Disable (SRWD) bit is set to 1, and Write Protect (

W ) is

driven Low). In this mode, the non-volatile bits of the Status

the Write Status Register (WRSR) instruction is no longer

accepted for execution.

Figure 6. Read Status Register (RDSR) Instruction Sequence and Data-Out Sequence

810

911 12 13 14 15

MSB

Status Register Out

High Impedance

Instruction

01 2 3 4 5 6 7

DIO

A25LS512A 数据表(PDF) 12 Page - AMIC Technology

A25LS512A 数据表(HTML) 12 Page - AMIC Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

数据表下载