| 数据搜索系统,热门电子元器件搜索 |
|
USB3503 数据表(PDF) 18 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
USB3503 数据表(HTML) 18 Page - Microchip Technology |
|
18 / 73 page ![]() USB3503 DS00001584B-page 18 2011-2015 Microchip Technology Inc. 4.3.4 HUB CONNECT STAGE (HUB.CONNECT) Next, the USB3503 enters the Hub Connect Stage. See Section 5.3.32, "Register EEh: Configure Portable Hub - CFGP," on page 31 and Section 5.3.29, "Register E7h: Serial Port Interlock Control - SP_ILOCK," on page 29 for definition of control registers which affect how the device transitions through the hub stages. By using the appropriate controls, the USB3503 can be set to immediately transition, or instead to remain in the Hub Connect Stage indefinitely until one of the SOC handshake events occur. When set to wait on the handshake, the SOC may read or update any of the serial port registers. Once the SOC finishes accessing registers and is ready for USB communication to start, it can perform one of the selected handshakes which that cause the USB3503 to connect within Thubconnect and transition to the Hub Communication Stage. 4.3.5 HUB COMMUNICATION STAGE (HUB.COM) Once it exits the Hub Connect Stage, the USB3503 enters Hub Communication Stage. In this stage full USB operation is supported under control of the USB Host on the upstream port. The USB3503 will remain in the Hub Communication Stage until the operating mode is changed by the system asserting RESET_N low. While in the Hub Communication Stage, communication over the serial port is no longer supported and the resulting behavior of the serial port if accessed is undefined. In order to re-enable the serial port interface, the device must exit Hub Communication Stage. Exiting this stage is only possible by entering Standby mode. 4.3.6 HUB MODE TIMING DIAGRAM The following timing diagram shows the progression through the stages of Hub Mode and the associated timing param- eters. The following table lists the timing parameters associated with the stages of the Hub Mode. FIGURE 4-2: TIMING DIAGRAM FOR HUB STAGES TABLE 4-2: TIMING PARAMETERS FOR HUB STAGES Characteristic Symbol MIN TYP MAX Units Conditions Hub Initialization Time THUBINIT 34 ms Hub Configuration Time-out THUBCONFIG 94 95 96 ms Hub Connect Time THUBCONNECT 01 10 us RESET_N Device Mode.Stage T_HUBINIT Standby Hub.Init Hub.Config T_HUBCONFIG Hub.Connect T_HUBCONNECT Hub.Com |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |