AP0101CS datasheet(20/42 Pages) ONSEMI

20 / 42 page

AP0101CS/D Rev. 7, 1/16 EN

©Semiconductor Components Industries, LLC,2016.

AP0101CS HDR: Image Signal Processor (ISP)

Image Flow Processor

the user or automatically selected by the auto white balance (AWB) algorithm imple-

mented in the IFP. Color correction should ideally produce output colors that are

corrected for the spectral sensitivity and color crosstalk characteristics of the image

sensor. The optimal values of the color correction matrix elements depend on those

sensor characteristics and on the spectrum of light incident on the sensor. The color

correction variables can be adjusted through register settings.

To increase image sharpness, a programmable 2D aperture correction (sharpening filter)

is applied to color-corrected image data. The gain and threshold for 2D correction can

be defined through register settings.

Gamma Correction

The gamma correction curve is implemented as a piecewise linear function with 33 knee

points, taking 12-bit arguments and mapping them to 10-bit output. The abscissas of the

knee points are fixed at 0, 8, 16, 24, 32, 40, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224, 256,

320, 384, 448, 512, 640, 768, 896, 1024, 1280, 1536, 1792, 2048, 2560, 3072, 3584, and 4096.

The 10-bit ordinates are programmable through variables.

The AP0101CS has the ability to calculate the 33-point knee points based on the tuning

of cam_ll_gamma and cam_ll_contrast_gradient_bright. The other method is for the

host to program the 33 knee point curve themselves.

Also included in this block is a Fade-to Black curve which sets all knee points to zero and

causes the image to go black in extreme low light conditions.

Color Kill

To remove high-or low-light color artifacts, a color kill circuit is included. It affects only

pixels whose luminance exceeds a certain preprogrammed threshold. The U and V

values of those pixels are attenuated proportionally to the difference between their lumi-

nance and the threshold.

YUV Color Filter

As an optional processing step, noise suppression by one-dimensional low-pass filtering

of Y and/or UV signals is possible. A 3- or 5-tap filter can be selected for each signal.

AP0101CS 数据表(PDF) 20 Page - ON Semiconductor