CS42406 datasheet(19/50 Pages) CIRRUS

19 / 50 page

CS42406

DC ELECTRICAL CHARACTERISTICS GND = 0 V; all voltages with respect to GND.

Notes: 14. Normal operation is defined as RST = HI with a 997 Hz, 0 dBFS digital input sampled at the highest Fs

for each speed mode, and open outputs, unless otherwise specified. Analog inputs are driven with a 1

kHz, -1 dBFS sine wave and sampled at the highest Fs for each speed mode.

15. IDT measured with no external loading on pin 14 (SDA).

16. Power Down Mode is defined as DAC_RST = LO, PDN_ADC = LO, with all clocks and data lines held

static.

17. Valid with the recommended capacitor values on FILT+ and VQ as shown in Figure 33.

Parameters

Symbol

Min

Typ

Max

Units

Normal Operation (Note 14)

Power Supply Current

VA = 5.0 V

VD, VLS, VLC = 5.0 V

VA = 3.3 V

VD, VLS, VLC = 3.3 V

(Note 15)

IDT

Power Dissipation

All Supplies = 5.0 V

All Supplies = 3.3 V

415

215

465

231

Power-down Mode (Note 16)

Power Supply Current

All Supplies = 5.0 V

All Supplies = 3.3 V

Power Dissipation

All Supplies = 5.0 V

All Supplies = 3.3 V

3.3

All Modes of Operation

Power Supply Rejection Ratio (Note 17)

1 kHz

PSRR

VQ Nominal Voltage

Output Impedance

DAC_VQ

ADC_VQ

Maximum allowable DC current source/sink

0.5•VA

250

0.01

Ω

Filt+ Nominal Voltage

MUTEC Low-Level Output Voltage

MUTEC High-Level Output Voltage

Maximum MUTEC Drive Current

CS42406 数据表(PDF) 19 Page - Cirrus Logic

CS42406 数据表(HTML) 19 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

数据表下载

链接网址

CS42406 数据表(PDF) 19 Page - Cirrus Logic

CS42406 数据表(HTML) 19 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

数据表 下载

链接网址

数据表下载