4LS5K datasheet(31/115 Pages) OSRAM

31 / 115 page

Document Feedback

4LS

Functional Description

Datasheet

• PUBLIC

DS000542

• v3-01 • 2022-Nov-17

114

│ 30

7.5

Automatic Start A/D Conversion and Readout

The sensor features the possibility for the user to place it in semi-automatic mode. In this operation

mode the user only needs to act over the reset signal for CDS and CVC, and the SAMPLE signal.

The start of A/D conversion and the start for the readout will be performed automatically and the data

will be sent to the user with no need for any additional action. To set the sensor to this operation mode

it is necessary to set the bits 4 and 5 of register Status 2 to '1'.

It is also possible to set only one of the operations to automatic. As an example, the start of readout

can be set to automatic and the conversion set to manual, so the user needs to start the conversion by

the START_AD signal, and, as soon the conversion is over, the sensor will start the readout

automatically. Also if only the A/D conversion is set to be performed automatically, the sensor will start

as soon as the integration and the readout of previous line is finished, then it is the user’s

responsibility to trigger the readout by the START_READOUT signal of the converted line.

Despite the fact that these features are available and working, it is recommended to use perform the

A/D conversion and readout using external signals, once these were applied for the sensor

characterization phase and currently used in the Evaluation Kit (EK) system. For more details,

regarding implementation, please refer to section 7.11.

7.6

LVDS Output Data Interface

The data of each segment is communicated off chip via a serial LVDS interface. The LVDS output

data interfaces are organized in 16 LVDS data outputs, 4 on each line, on top and on bottom. In

addition to the data interface, there are 2 LVDS data clock interface, for deserialization purposes: one

on top and another on bottom.

The LVDS output current can be programmable over the SPI interface (register Programmable LVDS

the current from 400 µA to 2.8 mA with steps of 400 µA. This driving current can be reduced

(decreasing the noise coupling to the analogue electronics) or increased based on voltage swing

LVDS receiver. Additional, if needed, can also be switched off, drivers setting the configuration bits at

'000'.

A schematic, presenting the principle used of the LVDS transmitter, is presented on Figure 39.

4LS5K 数据表(PDF) 31 Page - OSRAM GmbH

4LS5K 数据表(HTML) 31 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载