| 数据搜索系统,热门电子元器件搜索 |
|
M41T82 数据表(PDF) 39 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
M41T82 数据表(HTML) 39 Page - STMicroelectronics |
|
39 / 61 page ![]() M41T82-M41T83 Clock operation Doc ID 12578 Rev 12 39/61 3.10 Battery low warning The M41T8x automatically checks the battery each time VCC powers up and each time the clock rolls over at midnight. VBAT is compared to VBL (approximately 2.5 V), then the battery low (BL) bit, D4 of flags register 0Fh, is set if the battery voltage is found to be less than VBL. Similarly, if VBAT is greater than VBL, the BL bit is cleared during battery check. The BL bit retains its state until the next battery check occurs. This means the BL bit will not clear immediately upon battery replacement, but only after the next battery check occurs at the next power-up or midnight rollover. If a battery low is generated during a power-up sequence, this indicates that the battery is below approximately 2.5 volts and may not be able to maintain data integrity. Clock data should be considered suspect and verified as correct. A fresh battery should be installed. If a battery low indication is generated during the 24-hour interval check, this indicates that the battery is near end of life. However, data is not compromised due to the fact that a nominal VCC is supplied. In order to ensure data integrity during subsequent periods of battery backup mode, the battery should be replaced. Midnight rollover check As shown in Figure 22, during the midnight rollover check, the M41T8x applies a load to the battery, then compares VBAT to VBL and updates the BL bit accordingly. Because a load is present, an open condition on the VBAT pin will result in the BL bit being set. After the check is performed, the RTC removes the load. Power-up battery check During the power-up check, no load is applied to the battery under the assumption the battery has already been stressed to its working level by having powered the RTC in backup mode. If no battery is present, VBAT will be floating and the battery check result will be indeterminate. Figure 22. Battery check V BAT V BL=2.5V Only at rollover BL FF Q S R At power-up and at rollover RL AM03009v1 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |