SPEAR300 datasheet(21/83 Pages) STMICROELECTRONICS

21 / 83 page

SPEAr300

Architecture overview

Doc ID 16324 Rev 2

21/83

2.18

I2S interface

The I2S interface is very similar to the TDM block, but the frame sync is limited to Philips I2S

definition. It is composed of 4 signals:

●

I2S_LRCK; Left and right channels synchronization (Master/slave)

●

I2S_CLK: I2S clock (Master/slave)

●

I2S_DIN: I2S clock (Master/slave)

●

I2S DOUT: I2S output (tri-state)

The DOUT line can be high impedance when out of samples. Data is always stored in 32 bit

format in the buffer. A shift left operation is possible to left align the data.

Main features:

●

Can be master or slave for the clock and sync signals

●

Buffering of up to 1024 samples (512 left and 512 right samples representing 64 ms of

voice). Data is stored always on 32 bits.

●

Left and right channels are stored in two different buffers.

●

Two banks are used to exchange data with the processor.

●

In master mode, LRCK can be adjusted for 8, 16 or 32 bits width.

●

Data width can be less than LRCK width. Input (received on I2S_DIN) and output

(transmitted on DOUT) can be 8, 16 or 32 bits.

2.19

GPIOs

The General Purpose Input/Outputs (GPIOs) provide programmable inputs or outputs.

Main features:

●

Individually programmable input/output pins implemented in 3 blocks:

–

Up to 6 base GPIOs in the basic subsystem (basGPIO)

–

Up to 18 GPIOs in the RAS subsystem (G10 and G8)

–

Up to 18 GPIOs in the keyboard controller

–

Up to 8 GPIOs in the independent GPIO block (GPIO[7:0])

●

Programmable interrupt generation capability up to 22 pins.

●

Base GPIOs and independent GPIOs support bit masking in both read and write

operation through address lines.

Up to 62 general purpose I/Os are available in Mode 4 (LEND_IP_ph) (see Table 10).

●

In this mode the application can use:

–

10 GPIOs in G10 block

–

8 GPIOs in G8 block (0 to 3 in output mode only)

–

18 GPIO (keyboard controller I/Os in GPIO mode)

–

6 base GPIOs (basGPIO) (enabled as alternate functions (see Table 11)

–

8 IT pins (input only, with interrupt capability)

–

4 SYNC outputs (SYNC4-7)

–

8 SPI_I2C outputs

SPEAR300 数据表(PDF) 21 Page - STMicroelectronics

SPEAR300 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83

数据表下载