ATPL230A datasheet(37/122 Pages) ATMEL

37 / 122 page

ATPL230A [DATASHEET]

Atmel-43053J-ATPL230A-Datasheet_22-Sep-16

8.3.1.11 Peripheral CRC Configuration Register

Name:

VCRC_CONF

Address:

0xFF16

Access:

Read/Write

Reset:

0xC3

This is an 8 bits register used to configure different CRC´s and LFSR´s. This register contains the following control

bits:

• FB_TYPE:

Configures desired circuit feedback type

‘0’: Select circuit feedback type as below.

‘1’: Select circuit feedback type as below.

• MSBF:

Allows to choose byte calculation mode

‘0’: Select the least significant bit (LSB) first to start calculations.

‘1’: Select the most significant bit (MSB) first to start calculations.

• MIRRORED8:

Allows to flip (turn over) the desired CRC size (bytes) in the 32-bit VCRC_CRC register configured by WIDTH1

and WIDTH0 bits.

‘0’: No flipping is performed and the 32-bit VCRC_CRC register will remain unalterable as below.

‘1’: Flip the desired CRC size (bytes) in the 32-bit VCRC_CRC register configured by the control bits WIDTH1

and WIDTH0. For example, if control bits WIDTH1 and WIDTH0 are both set to ‘1’ (CRC size = 4, see link

table), it will flip the four blocks of bytes in the register. In another case when CRC size = 3 (WIDTH1=’1’ and

WIDTH0=’0’), it will flip the first three blocks of bytes (beginning from less significant byte) in the register

ignoring the last byte.

3210

FB_TYPE

MSBF

MIRRORED32

MIRRORED8

CIN

COUT

WIDTH1

WIDTH0

Input

X^5

X^4

X^3

X^2

X^1

X^0

Input

X^5

X^4

X^3

X^2

X^1

X^0

ATPL230A 数据表(PDF) 37 Page - ATMEL Corporation

ATPL230A 数据表(HTML) 37 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载