GS3471 datasheet(57/179 Pages) SEMTECH

57 / 179 page

GS3471

Final Data Sheet Rev.4

PDS-060498

September 2017

57 of 179

Semtech

www.semtech.com

By default (after power up or after systems reset), the four

RASTER_STRUC_[4:1]_DS[2:1], VD_STD_DS[2:1], STD_LOCK_DS[2:1], and

INT_PROG_DS[2:1] fields are set to zero. These fields are also cleared when the

SMPTE_BYPASS register is LOW.

4.16 Data Format Detection & Indication

In addition to detecting the video standard, the GS3471 also detects the data format.

This information can be found in the DATA_FORMAT_DS[2:1] registers. Data format

information is only accessible while the device is locked. By default, at power-up, after

reset or while the device is not locked, the DATA_FORMAT_DS[2:1] registers are set to

Fh.

The data format is determined based on the presence of TRS ID words, SDTI header and

TDM header.

Note: In SD video mode only the Y data format register contains the data, and the C

Table 4-12: Data Format Register Codes

YDATA_FORMAT[3:0] or

CDATA_FORMAT[3:0]

Data Format

Remarks

0h to 05h

SDTI

SMPTE ST 321, SMPTE ST 322,



SMPTE ST 326

SDI

—

Reserved

—

TDM

SMPTE ST 346

HD-SDTI

—

Ah to Eh

Reserved

—

Non-SMPTE data format

Detected data format is not SMPTE.



LOCKED = LOW.

Note: This Data Format register is

invalid in SMPTE_BYPASS mode.

GS3471 数据表(PDF) 57 Page - Semtech Corporation

GS3471 数据表(HTML) 57 Page - Semtech Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载