| 数据搜索系统,热门电子元器件搜索 |
|
ADBMS1818ASWZ-R7 数据表(PDF) 24 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
ADBMS1818ASWZ-R7 数据表(HTML) 24 Page - Analog Devices |
|
24 / 89 page ![]() Data Sheet ADBMS1818 THEORY OF OPERATION analog.com Rev. 0 | 24 of 89 ADC Range and Resolution The C inputs and GPIO inputs have the same range and resolution. The ADC inside the ADBMS1818 has an approximate range from –0.82 V to +5.73 V. Negative readings are rounded to 0 V. The format of the data is a 16-bit unsigned integer where the LSB rep- resents 100 μV. Therefore, a reading of 0x80E8 (33,000 decimal) indicates a measurement of 3.3 V. Δ-Σ ADCs have quantization noise which depends on the input voltage, especially at low oversampling ratios, such as in fast mode. In some of the ADC modes, the quantization noise increases as the input voltage approaches the upper and lower limits of the ADC range. For example, the total measurement noise vs. input voltage in normal and filtered modes is shown in Figure 54. The specified range of the ADC is 0 V to 5 V. In Table 18, the preci- sion range of the ADC is arbitrarily defined as 0.5 V to 4.5 V. This range is where the quantization noise is relatively constant even in the lower OSR modes (see Figure 54). Table 18 summarizes the total noise in this range for all eight ADC operating modes. Also shown in Table 18 is the noise free resolution. For example, 14-bit noise free resolution in normal mode implies that the top 14 bits are noise free with a dc input, but that the 15th and 16th LSBs flicker. Figure 54. Measurement Noise vs. Input Voltage ADC Range vs. Voltage Reference Value Typical ADCs have a range that is exactly twice the value of the voltage reference, and the ADC measurement error is directly proportional to the error in the voltage reference. The ADBMS1818 ADC is not typical. The absolute value of VREF1 is trimmed up or down to compensate for gain errors in the ADC. Therefore, the ADC TME specifications are superior to the VREF1 specifications. For example, the 25°C specification of the TME when measuring 3.300 V in 7 kHz (normal) mode is ±3 mV, and the 25°C specification for VREF1 is 3.150 V ± 150 mV. Measuring Cell Voltages (ADCV Command) The ADCV command initiates the measurement of the battery cell inputs, Pin C0 through Pin C18. This command has options to select the number of channels to measure and the ADC mode. See the Commands section for the ADCV command format. Figure 55 shows the timing of the ADCV command that measures all 18 cells. After the receipt of the ADCV command to measure all 18 cells, ADC1 sequentially measures the bottom 6 cells. ADC2 measures the middle 6 cells and ADC3 measures the top 6 cells. After the cell measurements complete, each channel is calibrated to remove any offset errors. Table 19 shows the conversion times for the ADCV command measuring all 18 cells. The total conversion time is given by t6C which indicates the end of the calibration step. Figure 56 shows the timing of the ADCV command that measures only 3 cells. Table 18. ADC Range and Resolution Mode Full Range1 Specified Range Precision Range2 LSB Format Maximum Noise Noise Free Resolution3 27 kHz (Fast) –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±4 mV p-p 10 bits 14 kHz –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±1 mV p-p 12 bits 7 kHz (Normal) –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±250 μV p-p 14 bits 3 kHz –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±150 μV p-p 14 bits 2 kHz –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±100 μV p-p 15 bits 1 kHz –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±100 μV p-p 15 bits 422 Hz –0.8192 V to +5.7344 V 0 V to 5 V 0.5 V to 4.5 V 100 μV Unsigned 16 bits ±100 μV p-p 15 bits |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |