AT83C5136-RDTUL datasheet(77/171 Pages) ATMEL

77 / 171 page

AT83C5134/35/36

7683B–USB–03/07

pins (Figure 34). To prevent bus conflicts on the MISO line, only one slave should be

selected at a time by the Master for a transmission.

In a Master configuration, the SS line can be used in conjunction with the MODF flag in

the SPI Status register (SPSTA) to prevent multiple masters from driving MOSI and

SCK (see Section “Error Conditions”, page 81).

A high level on the SS pin puts the MISO line of a Slave SPI in a high-impedance state.

The SS pin could be used as a general-purpose if the following conditions are met:

•

The device is configured as a Master and the SSDIS control bit in SPCON is set.

This kind of configuration can be found when only one Master is driving the network

and there is no way that the SS pin could be pulled low. Therefore, the MODF flag in

the SPSTA will never be set(1).

•

The Device is configured as a Slave with CPHA and SSDIS control bits set(2) This

kind of configuration can happen when the system comprises one Master and one

Slave only. Therefore, the device should always be selected and there is no reason

that the Master uses the SS pin to select the communicating Slave device.

Notes:

1. Clearing SSDIS control bit does not clear MODF.

2. Special care should be taken not to set SSDIS control bit when CPHA =’0’ because in

this mode, the SS is used to start the transmission.

Baud Rate

In Master mode, the baud rate can be selected from a baud rate generator which is con-

trolled by three bits in the SPCON register: SPR2, SPR1 and SPR0. The Master clock is

chosen from one of seven clock rates resulting from the division of the internal clock by

2, 4, 8, 16, 32, 64 or 128.

Table 64 gives the different clock rates selected by SPR2:SPR1:SPR0:

Table 64. SPI Master Baud Rate Selection

SPR2

SPR1

SPR0

Clock Rate

Baud Rate Divisor (BD)

Don’t Use

No BRG

FCLK PERIPH/4

FCLK PERIPH/8

FCLK PERIPH/16

FCLK PERIPH/32

FCLK PERIPH/64

FCLK PERIPH/128

128

Don’t Use

No BRG

AT83C5136-RDTUL 数据表(PDF) 77 Page - ATMEL Corporation

AT83C5136-RDTUL 数据表(HTML) 77 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载