AT83C5136-RDTUL datasheet(10/171 Pages) ATMEL

10 / 171 page

AT83C5134/35/36

7683B–USB–03/07

Table 10. USB Signal Description

Table 11. System Signal Description

Signal

Name

Type

Description

Alternate

Function

D+

I/O

USB Data + signal

Set to high level under reset.

D-

I/O

USB Data - signal

Set to low level under reset.

VREF

USB Reference Voltage

Connect this pin to D+ using a 1.5 kΩ resistor to use the Detach function.

Signal

Name

Type

Description

Alternate

Function

AD[7:0]

I/O

Multiplexed Address/Data LSB for external access

Data LSB for Slave port access (used for 8-bit and 16-bit modes)

P0[7:0]

A[15:8]

I/O

Address Bus MSB for external access

Data MSB for Slave port access (used for 16-bit mode only)

P2[7:0]

I/O

Read Signal

Read signal asserted during external data memory read operation.

Control input for slave port read access cycles.

P3.7

I/O

Write Signal

Write signal asserted during external data memory write operation.

Control input for slave write access cycles.

P3.6

RST

I/O

Reset

Holding this pin low for 64 oscillator periods while the oscillator is running

resets the device. The Port pins are driven to their reset conditions when a

voltage lower than VIL is applied, whether or not the oscillator is running.

This pin has an internal pull-up resistor which allows the device to be reset

by connecting a capacitor between this pin and VSS.

Asserting RST when the chip is in Idle mode or Power-down mode returns

the chip to normal operation.

This pin is set to 0 for at least 12 oscillator periods when an internal reset

occurs (hardware watchdog or Power monitor).

ALE

Address Latch Enable Output

The falling edge of ALE strobes the address into external latch. This signal

is active only when reading or writing external memory using MOVX

instructions.

PSEN

Program Strobe Enable / Hardware conditions Input for ISP

Used as input under reset to detect external hardware conditions of ISP

mode

External Access Enable

This pin must be held low to force the device to fetch code from external

program memory starting at address 0000h. It is latched during reset and

cannot be dynamically changed during operation.

AT83C5136-RDTUL 数据表(PDF) 10 Page - ATMEL Corporation

AT83C5136-RDTUL 数据表(HTML) 10 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载