| 数据搜索系统,热门电子元器件搜索 |
|
AT83C5136-RDTUL 数据表(PDF) 30 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
AT83C5136-RDTUL 数据表(HTML) 30 Page - ATMEL Corporation |
|
30 / 171 page ![]() 30 AT83C5134/35/36 7683B–USB–03/07 Stacked EEPROM Overview The AT83C5134/35/36 features a stacked 2-wire serial data EEPROM. The data EEPROM allows to save from 512 Byte for AT24C04 version up to 32 Kbytes for AT24C256 version. The EEPROM is internally connected to the microcontroller on SDA and SCL pins. Protocol In order to access this memory, it is necessary to use software subroutines according to the AT24Cxx datasheet. Nevertheless, because the internal pull-up resistors of the AT83C5134/35/36 is quite high (around 100KΩ), the protocol should be slowed in order to be sure that the SDA pin can rise to the high level before reading it. Another solution to keep the access to the EEPROM in specification is to work with a software pull-up. Using a software pull-up, consists of forcing a low level at the output pin of the microcon- troller before configuring it as an input (high level). The C51 the ports are “quasi-bidirectional” ports. It means that the ports can be config- ured as output low or as input high. In case a port is configured as an output low, it can sink a current and all internal pull-ups are disconnected. In case a port is configured as an input high, it is pulled up with a strong pull-up (a few hundreds Ohms resistor) for 2 clock periods. Then, if the port is externally connected to a low level, it is only kept high with a weak pull up (around 100KΩ), and if not, the high level is latched high thanks to a medium pull (around 10kΩ). Thus, when the port is configured as an input, and when this input has been read at a low level, there is a pull-up of around 100KΩ, which is quite high, to quickly load the SDA capacitance. So in order to help the reading of a high level just after the reading of a low level, it is possible to force a transition of the SDA port from an input state (1), to an output low state (0), followed by a new transition from this output low state to input state; In this case, the high pull-up has been replaced with a low pull-up which warran- ties a good reading of the data. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |