MPC8541ECVTALF datasheet(75/84 Pages) FREESCALE

75 / 84 page

MPC8541E PowerQUICC™ III Integrated Communications Processor Hardware Specifications, Rev. 4

Freescale Semiconductor

System Design Information

17 System Design Information

This section provides electrical and thermal design recommendations for successful application of the

MPC8541E.

17.1

System Clocking

The MPC8541E includes five PLLs.

1. The platform PLL (AVDD1) generates the platform clock from the externally supplied SYSCLK

input. The frequency ratio between the platform and SYSCLK is selected using the platform PLL

ratio configuration bits as described in Section 15.2, “Platform/System PLL Ratio.”

2. The e500 Core PLL (AVDD2) generates the core clock as a slave to the platform clock. The

frequency ratio between the e500 core clock and the platform clock is selected using the e500

PLL ratio configuration bits as described in Section 15.3, “e500 Core PLL Ratio.”

3. The CPM PLL (AVDD3) is slaved to the platform clock and is used to generate clocks used

internally by the CPM block. The ratio between the CPM PLL and the platform clock is fixed and

not under user control.

4. The PCI1 PLL (AVDD4) generates the clocking for the first PCI bus.

5. The PCI2 PLL (AVDD5) generates the clock for the second PCI bus.

17.2

PLL Power Supply Filtering

Each of the PLLs listed above is provided with power through independent power supply pins (AVDD1,

AVDD2, AVDD3, AVDD4, and AVDD5 respectively). The AVDD level should always be equivalent to VDD,

and preferably these voltages will be derived directly from VDD through a low frequency filter scheme

such as the following.

There are a number of ways to reliably provide power to the PLLs, but the recommended solution is to

provide five independent filter circuits as illustrated in Figure 48, one to each of the five AVDD pins. By

providing independent filters to each PLL the opportunity to cause noise injection from one PLL to the

other is reduced.

This circuit is intended to filter noise in the PLLs resonant frequency range from a 500 kHz to 10 MHz

range. It should be built with surface mount capacitors with minimum Effective Series Inductance (ESL).

Consistent with the recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook

of Black Magic (Prentice Hall, 1993), multiple small capacitors of equal value are recommended over a

single large value capacitor.

Each circuit should be placed as close as possible to the specific AVDD pin being supplied to minimize

noise coupled from nearby circuits. It should be possible to route directly from the capacitors to the AVDD

pin, which is on the periphery of the 783 FC-PBGA footprint, without the inductance of vias.

MPC8541ECVTALF 数据表(PDF) 75 Page - Freescale Semiconductor, Inc

MPC8541ECVTALF 数据表(HTML) 75 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

数据表下载