ST7FOXK2 datasheet(84/226 Pages) STMICROELECTRONICS

84 / 226 page

On-chip peripherals

ST7FOXF1, ST7FOXK1, ST7FOXK2

84/226

10.2.3

Functional description

PWM mode

This mode allows up to four Pulse Width Modulated signals to be generated on the PWMx

output pins.

●

PWM frequency

The four PWM signals can have the same frequency (fPWM) or can have two different

frequencies. This is selected by the ENCNTR2 bit which enables Single Timer or Dual

Timer mode (see Figure 35 and Figure 36). The frequency is controlled by the counter

period and the ATR register value. In Dual Timer mode, PWM2 and PWM3 can be

generated with a different frequency controlled by CNTR2 and ATR2.

Following the above formula, if fCOUNTER equals 4 MHz, the maximum value of fPWM is

2 MHz (ATR register value = 4094), and the minimum value is 1 kHz (ATR register

value = 0).

The maximum value of ATR is 4094 because it must be lower than the DC4R value

which must be 4095 in this case.

●

Duty cycle

The duty cycle is selected by programming the DCRx registers. These are preload

registers. The DCRx values are transferred in Active duty cycle registers after an

overflow event if the corresponding transfer bit (TRANx bit) is set.

The TRAN1 bit controls the PWMx outputs driven by counter 1 and the TRAN2 bit

controls the PWMx outputs driven by counter 2.

PWM generation and output compare are done by comparing these active DCRx

values with the counter.

The maximum available resolution for the PWMx duty cycle is:

where ATR is equal to 0. With this maximum resolution, 0% and 100% duty cycle can

be obtained by changing the polarity.

At reset, the counter starts counting from 0.

When a upcounter overflow occurs (OVF event), the preloaded Duty cycle values are

transferred to the active Duty Cycle registers and the PWMx signals are set to a high

level. When the upcounter matches the active DCRx value the PWMx signals are set to

a low level. To obtain a signal on a PWMx pin, the contents of the corresponding active

DCRx register must be greater than the contents of the ATR register.

The maximum value of ATR is 4094 because it must be lower than the DCR value

which must be 4095 in this case.

●

Polarity inversion

The polarity bits can be used to invert any of the four output signals. The inversion is

synchronized with the counter overflow if the corresponding transfer bit in the ATCSR2

PWM

COUNTER

4096

ATR

–

()

⁄

Resolution

4096

ATR

–

()

⁄

ST7FOXK2 数据表(PDF) 84 Page - STMicroelectronics

ST7FOXK2 数据表(HTML) 84 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载