ST7FOXK2 datasheet(36/226 Pages) STMICROELECTRONICS

36 / 226 page

Supply, reset and clock management

ST7FOXF1, ST7FOXK1, ST7FOXK2

36/226

If a programming cycle is interrupted (by a RESET action), the integrity of the data in

memory will not be guaranteed.

Caution:

When the Read-Out Protection is enabled through an option bit (see Section 13.1: Option

bytes), these two bytes are protected against Read-out (including a re-write protection). In

Flash devices, when this protection is removed by reprogramming the option byte, these two

bytes are automatically erased.

Figure 10.

RC user calibration programming cycle

6.1.3

Auto wakeup RC oscillator

The ST7FOX also contains an Auto wakeup RC oscillator. This RC oscillator should be

enabled to enter Auto wakeup from halt mode.

The Auto wakeup (AWU) RC oscillator can also be configured as the startup clock through

the CKSEL[1:0] option bits (see Section 13.1: Option bytes on page 211).

This is recommended for applications where very low power consumption is required.

Switching from one startup clock to another can be done in run mode as follows (see

Figure 11):

Case 1 Switching from internal RC to AWU

Set the RC/AWU bit in the CKCNTCSR register to enable the AWU RC oscillator

The RC_FLAG is cleared and the clock output is at 1.

Wait 3 AWU RC cycles till the AWU_FLAG is set

The switch to the AWU clock is made at the positive edge of the AWU clock signal

Once the switch is made, the internal RC is stopped

RCCLAT

ERASE CYCLE

WRITE CYCLE

RCCPGM

tPROG

READ OPERATION NOT POSSIBLE

WRITE OF

DATA LATCHES

READ OPERATION POSSIBLE

Internal

Programming

voltage

Byte 1 Byte 2

tPROG is typically 5 ms and max 10 ms

ST7FOXK2 数据表(PDF) 36 Page - STMicroelectronics

ST7FOXK2 数据表(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载