EM78P468NBQSSLASHNBQJ datasheet(25/82 Pages) EMC

25 / 82 page

EM78P468N/L

8-Bit Microcontroller

Product Specification (V1.6) 12.31.2007

• 19

(This specification is subject to change without further notice)

Bit 2 (/WUE8L):

0/1

→ enable/disable P8.0~P8.3 pin change wake-up function

Bit 1 (/WUE6H):

0/1

→ enable/disable P6.4~P6.7 pin change wake-up function

Bit 0 (/WUE6L):

0/1

→ enable/disable P6.0~P6.3 pin change wake-up function

* Port 6 and Port 8 must not be set as input floating when wake-up function is

enabled. “Enable” is the initial state of wake-up function.

6.2.14 IOC71/TCCCR (TCC Control Register)

(Address: 07h, Bit 0 of R5 = “1”)

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

INT_EDGE

INT

PSRE

TCCP2

TCCP1

TCCP0

Bit 7 (INT_EDGE):

INT_EDGE = “0”:

Interrupt on the rising edge of P5.4/INT0 pin

INT_EDGE = “1”:

Interrupt on the falling edge of P5.4/INT0 pin

Bit 6 (INT):

INT enable flag, this bit is read only

INT = “0”:

interrupt masked by DISI or hardware interrupt

INT = “1”:

interrupt enabled by ENI/RETI instructions

Bit 5 (TS):

TCC signal source

TS = “0”:

internal instruction cycle clock

TS = “1”:

transition on TCC pin, TCC period > internal instruction clock period

Bit 4 (TE):

TCC signal edge

TE = “0”:

incremented by TCC pin rising edge

TE = “1”:

incremented by TCC pin falling edge

Bits 3~0 (PSRE, TCCP2 ~ TCCP0):

TCC prescaler bits.

PSRE

TCCP2

TCCP1

TCCP0

TCC Rate

1:1

1:2

1:4

1:8

1:16

1:32

1:64

1:128

1:256

EM78P468NBQS/NBQJ 数据表(PDF) 25 Page - ELAN Microelectronics Corp

EM78P468NBQS/NBQJ 数据表(HTML) 25 Page - ELAN Microelectronics Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

数据表下载