AT80C51RA2-RLSIV datasheet(62/86 Pages) ATMEL

62 / 86 page

4188F–8051–01/08

AT/TS8xC51Rx2

Figure 11-3. ICC Test Condition, Idle Mode

Figure 11-4. ICC Test Condition, Power-Down Mode

Figure 11-5. Clock Signal Waveform for ICC Tests in Active and Idle Modes

11.5

AC Parameters

11.5.1

Explanation of the AC Symbols

Each timing symbol has 5 characters. The first character is always a “T” (stands for time). The

other characters, depending on their positions, stand for the name of a signal or the logical sta-

tus of that signal. The following is a list of all the characters and what they stand for.

Example:TAVLL = Time for Address Valid to ALE Low.

TLLPL = Time for ALE Low to PSEN Low.

TA = 0 to +70°C (commercial temperature range); VSS = 0 V; VCC = 5 V ± 10%; -M and -V ranges.

TA = -40°C to +85°C (industrial temperature range); VSS = 0 V; VCC = 5 V ± 10%; -M and -V

ranges.

RST

XTAL2

XTAL1

VSS

VCC

ICC

(NC)

VCC

All other pins are disconnected.

CLOCK

SIGNAL

Reset = Vss after a high pulse

during at least 24 clock cycles

RST

XTAL2

XTAL1

VSS

VCC

ICC

(NC)

VCC

All other pins are disconnected.

Reset = Vss after a high pulse

during at least 24 clock cycles

VCC-0.5V

0.45V

0.7VCC

0.2VCC-0.1

TCLCH

TCHCL

TCLCH = TCHCL = 5ns.

AT80C51RA2-RLSIV 数据表(PDF) 62 Page - ATMEL Corporation

AT80C51RA2-RLSIV 数据表(HTML) 62 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

数据表下载