ATmega169PV-8MCH datasheet(95/393 Pages) ATMEL

95 / 393 page

8018N–AVR–08/09

ATmega169P

14.5.3

Using the Output Compare Unit

Since writing TCNT0 in any mode of operation will block all compare matches for one timer clock

cycle, there are risks involved when changing TCNT0 when using the Output Compare unit,

independently of whether the Timer/Counter is running or not. If the value written to TCNT0

equals the OCR0A value, the compare match will be missed, resulting in incorrect waveform

generation. Similarly, do not write the TCNT0 value equal to BOTTOM when the counter is down

counting.

The setup of the OC0A should be performed before setting the Data Direction Register for the

port pin to output. The easiest way of setting the OC0A value is to use the Force Output Com-

pare (FOC0A) strobe bits in Normal mode. The OC0A Register keeps its value even when

changing between Waveform Generation modes.

Be aware that the COM0A1:0 bits are not double buffered together with the compare value.

Changing the COM0A1:0 bits will take effect immediately.

14.6

Compare Match Output Unit

The Compare Output mode (COM0A1:0) bits have two functions. The Waveform Generator

uses the COM0A1:0 bits for defining the Output Compare (OC0A) state at the next compare

match. Also, the COM0A1:0 bits control the OC0A pin output source. Figure 14-4 shows a sim-

plified schematic of the logic affected by the COM0A1:0 bit setting. The I/O Registers, I/O bits,

and I/O pins in the figure are shown in bold. Only the parts of the general I/O port control regis-

ters (DDR and PORT) that are affected by the COM0A1:0 bits are shown. When referring to the

OC0A state, the reference is for the internal OC0A Register, not the OC0A pin. If a System

Reset occur, the OC0A Register is reset to “0”.

Figure 14-4. Compare Match Output Unit, Schematic

The general I/O port function is overridden by the Output Compare (OC0A) from the Waveform

Generator if either of the COM0A1:0 bits are set. However, the OC0A pin direction (input or out-

put) is still controlled by the Data Direction Register (DDR) for the port pin. The Data Direction

ible on the pin. The port override function is independent of the Waveform Generation mode.

PORT

DDR

OCn

OCnx

Waveform

Generator

COMnx1

COMnx0

FOCn

clk

I/O

ATmega169PV-8MCH 数据表(PDF) 95 Page - ATMEL Corporation

ATmega169PV-8MCH 数据表(HTML) 95 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载