E2000 datasheet(77/104 Pages) INTEL

77 / 104 page

Datasheet

Thermal Specifications and Design Considerations

5.1.2

Thermal Metrology

The maximum and minimum case temperatures (TC) for the processor is specified in

Table 26. This temperature specification is meant to help ensure proper operation of

the processor. Figure 17 illustrates where Intel recommends TC thermal measurements

should be made. For detailed guidelines on temperature measurement methodology,

refer to the appropriate Thermal and Mechanical Design Guidelines (see Section 1.2).

5.2

Processor Thermal Features

5.2.1

Thermal Monitor

The Thermal Monitor feature helps control the processor temperature by activating the

thermal control circuit (TCC) when the processor silicon reaches its maximum operating

temperature. The TCC reduces processor power consumption by modulating (starting

and stopping) the internal processor core clocks. The Thermal Monitor feature must

be enabled for the processor to be operating within specifications. The

temperature at which Thermal Monitor activates the thermal control circuit is not user

configurable and is not software visible. Bus traffic is snooped in the normal manner,

and interrupt requests are latched (and serviced during the time that the clocks are on)

while the TCC is active.

When the Thermal Monitor feature is enabled, and a high temperature situation exists

(i.e., TCC is active), the clocks will be modulated by alternately turning the clocks off

and on at a duty cycle specific to the processor (typically 30–50%). Clocks often will

not be off for more than 3.0 microseconds when the TCC is active. Cycle times are

processor speed dependent and will decrease as processor core frequencies increase. A

small amount of hysteresis has been included to prevent rapid active/inactive

transitions of the TCC when the processor temperature is near its maximum operating

temperature. Once the temperature has dropped below the maximum operating

temperature, and the hysteresis timer has expired, the TCC goes inactive and clock

modulation ceases.

With a properly designed and characterized thermal solution, it is anticipated that the

TCC would only be activated for very short periods of time when running the most

power intensive applications. The processor performance impact due to these brief

periods of TCC activation is expected to be so minor that it would be immeasurable. An

Figure 17.

Case Temperature (TC) Measurement Location

37.5 mm

Measure TC atthis point

(geometric centerof the package)

37.5 mm

Measure TC atthis point

(geometric centerof the package)

E2000 数据表(PDF) 77 Page - Intel Corporation

E2000 数据表(HTML) 77 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载