STW4811MBRASLASHLF datasheet(45/85 Pages) STMICROELECTRONICS

45 / 85 page

STw4811M/STw4811N

Functional description

CD00131784

45/85

Figure 12.

Thermal threshold temperatures for ‘it_warn’ bit and VDDOK ball

4.4

USB OTG module

This transceiver complies with the USB specification;

●

Universal serial bus specification Rev 2.0

●

On the go supplement to the USB specification Rev 1.0-a

●

Car kit interface specification (see: OTG transceiver specification Rev 0.92)

The USB OTG Transceiver has two modes: USB mode and UART mode. It includes:

●

Full and low speed transceiver (12 Mbit/s and 1.5 Mbit/s data rate)

●

Support data line and VBUS pulsing session request

●

Contains Host Negotiation Protocol (HNP) command and

status register

●

Charge pump regulator (5 V at 100 mA) to supply VBUS line of the USB cable

●

VBUS pull-up and pull-down resistors as defined by Session Request Protocol (SRP)

●

VBUS threshold comparators

●

VUSB LDO internal regulator which provides power supply for the bus driver and

receiver.

●

ID line detector and interrupt generator

●

Dedicated I²C serial control interface

Note:

The transceiver complies with USB specification if Vbat is greater than 3.2 V.

‘it_warn’ bit

VDDOK ball

Temperature

Rising warning

threshold

Shutdown

threshold

All supplies

are turn “OFF”

STW4811MBRA/LF 数据表(PDF) 45 Page - STMicroelectronics

STW4811MBRA/LF 数据表(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

数据表下载