CDCM7005

SCAS793E – JUNE 2005 – REVISED FEBRUARY 2013

www.ti.com

This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.

ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.

DESCRIPTION

The CDCM7005 is a high-performance, low phase noise and low skew clock synchronizer that synchronizes a

VCXO (voltage controlled crystal oscillator) or VCO (voltage controlled oscillator) frequency to one of the two

reference clocks. The programmable pre-divider M and the feedback-dividers N and P give a high flexibility to the

frequency ratio of the reference clock to VC(X)O:

•

VC(X)O_IN / PRI_REF = (N x P) / M or

•

VC(X)O_IN / SEC_REF = (N x P) / M

VC(X)O_IN clock operates up to 2.2 GHz. Through the selection of external VC(X)O and loop filter components,

the PLL loop bandwidth and damping factor can be adjust to meet different system requirements.

The CDCM7005 can lock to one of two reference clock inputs (PRI_REF and SEC_REF), supports frequency

hold-over mode and fast-frequency-locking for fail-safe and increased system redundancy. The outputs of the

CDCM7005 are user definable and can be any combination of up to five LVPECL outputs or up to 10 LVCMOS

outputs. The LVCMOS outputs are arranged in pairs (Y0A:Y0B, Y1A:Y1B, …), so that each pair has the same

frequency. But each output can be separately inverted and disabled. The built in synchronization latches ensure

that all outputs are synchronized for low output skew.

All device settings, like outputs signaling, divider value, input selection, and many more, are programmable by

SPI (3-wire serial peripheral interface). SPI allows individually control of the device settings.

The device operates in 3.3-V environment and is characterized for operation from –40°C to 85°C.

2

Submit Documentation Feedback

Copyright © 2005–2013, Texas Instruments Incorporated

Product Folder Links :CDCM7005