3G5A2-RPT01-PE datasheet(78/182 Pages) OMRON

78 / 182 page

Output Surge Current

When connecting a Transistor or Triac Output Unit to an output device having a

high surge current (such as an incandescent lamp), care must be taken to avoid

damage to the Output Unit. The Transistor and Triac Output Units are capable of

withstanding a surge current of ten times the rated current. If the surge current

for a particular device exceeds this amount, use one of the following circuit con-

figurations to protect the Output Unit.

OUT

COM

The above circuit protects the Output Unit by letting the load draw a small current

(about one third the rated current) while the output is OFF, significantly reducing

the surge current. The following circuit reduces the surge current by employing a

current-limiting resistor.

OUT

COM

A Transistor Output Unit’s output cannot be directly connected to a TTL input

because of the transistor’s residual voltage. When connecting TTL circuits to

transistor Output Units, connect a pull-up resistor and a CMOS IC between the

two.

3-5-3 Wiring Examples

The following examples illustrate how to connect I/O devices to I/O Units. During

wiring, work slowly and carefully. If an input device is connected to an Output

Unit, damage may result. Check all I/O devices to make sure they meet the spec-

ifications (refer to

Appendix B Specifications). Be sure to allow for leakage cur-

rents and load inductance.

Input Units

DC Input Units

COM

Contact output

DC input

Transistor Output Residual

Voltage

Wiring I/O Units

Section 3-5

3G5A2-RPT01-PE 数据表(PDF) 78 Page - Omron Electronics LLC

3G5A2-RPT01-PE 数据表(HTML) 78 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载