3G5A2-RPT01-PE datasheet(85/182 Pages) OMRON

85 / 182 page

4-3

Output Unit Fuses

The following Output Units have one fuse each as shown in the table.

Output Unit

Fuse specifications

C500-OD411

C500-OD217

C500-OA223

250 V, 5 A

C500-OA121

C500-OA222

C500-OA226

250 V, 5 A

C500-OD219

250 V, 10 A

To replace a fuse in an Output Unit, perform the following steps.

1, 2, 3...

1. Turn off the power to the PC.

2. Detach the terminal block from the Output Unit by removing the screws lo-

cated at the top and bottom of the terminal block.

Mounting screws

Located at the top and bottom.

Terminal block mounting screws

Located at the top and bottom of

the terminal block.

Cover mounting screws (8)

3. Remove the screws that mount the Output Unit to the Backplane. Pulling the

Unit toward you, remove the Output Unit from the Backplane.

4. There are eight screws on each side of the Output Unit. Remove these

screws to detach the case from the cover.

5. Pull out the printed circuit board.

6. Insert a new fuse.

7. Reassemble the Unit.

4-4

Output Unit Relays

To replace a Relay in an Output Unit, take the following steps.

1, 2, 3...

1. Turn off the power to the PC.

Output Unit Relays

Section 4-4

3G5A2-RPT01-PE 数据表(PDF) 85 Page - Omron Electronics LLC

3G5A2-RPT01-PE 数据表(HTML) 85 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载