| 数据搜索系统,热门电子元器件搜索 |
|
ST802RT1AFR 数据表(PDF) 28 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST802RT1AFR 数据表(HTML) 28 Page - STMicroelectronics |
|
28 / 58 page ![]() Registers and descriptors description ST802RT1A, ST802RT1B 28/58 Doc ID 17049 Rev 1 Table 20. RN11 [0d17, 0x11]: Receiver configuration information and interrupt status register Bit Bit name Description Default RW type Type 15:11 RESERVED --- 00000b RO P 10 FX_MODE 1 -> FX mode set 0 -> FX mode not set If set to '1', auto-negotiation and scrambling is disabled. This bit can be set through an opportune hardware topology in ST802RT1B 0RO - 9 Speed 1 -> 100 Mb/s mode 0 -> 10 Mb/s mode This bit holds a valid value only if a link is already established 0RO - 8 Duplex 1 -> Full-duplex mode enabled 0 -> Half-duplex mode enabled This bit holds a valid value only if a link is already established 0RO - 7Pause 1 -> Pause is enabled 0 -> Pause is disabled Pause is active only after auto-negotiation completion, if both devices; support symmetric pause (RN04[10], RN05[10]) 0RO - 6 Auto neg interrupt 1 -> “Auto-negotiation completed” interrupt is pending 0 -> Auto-negotiation not yet completed Interrupt enabled by RN12[6] 0RO LH 5 Remote fault interrupt 1 -> “Remote fault condition” interrupt is pending 0 -> No remote fault condition detected Interrupt enabled by RN12[5] 0RO LH 4 Link down interrupt 1 -> “link status changed to fail” interrupt is pending 0 -> no link status changes Interrupt enabled by RN12[4] 0RO LH 3 Auto-Negotiation Link Code Word Received 1 -> “acknowledge match” interrupt is pending 0 -> no link code word received Interrupt enabled by RN12[3] 0RO LH 2 Link down interrupt 1 -> “Parallel Detection fault” interrupt is pending 0 -> No Parallel Detection faults Interrupt enabled by RN12[2] 0RO LH 1 Auto neg page received 1 -> “Auto-negotiation page received” interrupt is pending 0 -> no auto-negotiation page received Interrupt enabled by RN12[1] 0RO LH 0RX_FULL 1 -> “receive error buffer full” interrupt is pending (64k packet errors) 0 -> less than 64k error packets received Interrupt enabled by RN12[0]. Related counter is cleared after read 0RO LH |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |