VS6663CD datasheet(26/64 Pages) STMICROELECTRONICS

26 / 64 page

Camera control interface (CCI)

VS6663CD

26/64

Doc ID027033 Rev 2

4.2.5

Setup registers [0x0100 to 0x01FF]

Table 14. Setup registers [0x0100 to 0x01FF]

Index

Byte

Data type Default

Type

Comment

0x0100

mode_select

8UI

Mode select

0x00 - Software standby

0x01 - Streaming

Refer to Section 3.2: Device

operating modes on page 14

0x0101

image_orientation

Image orientation, that is, horizontal

mirror and vertical flip.

Bit 0: 0 - no mirror, 1 - horizontal

mirror enable

Bit 1: 0 - no flip, 1 - vertical flip

enable

0x0103

software_reset

8UI

Software reset. Setting this register

to 1 resets the sensor to its power

up defaults. The value of this bit is

also reset

0x00 - normal

0x01 - soft reset

Refer to Section 3.2: Device

operating modes on page 14

0x0104

grouped_parameter_hold

8UI

The grouped parameter hold

integration, gain and video timing

parameters

0x00 - consume parameters as

normal

0x01 - hold parameters

Refer to Section 6.3.3: Integration

and gain parameter retiming on

page 46

0x0105

mask_corrupted_frames

8UI

Setting this register to 1 prevents the

sensor outputing frames that have

been corrupted by video timing

parameter changes.

0x00 - normal

0x01 - mask corrupted frames

0x0110

csi_channel_identifier

8UI

The DMA (CCP2) or Virtual (CSI2)

channel identifier

Valid range: 0-7 for CCP2

Valid range: 0-3 for CSI-2

0x0111

csi_signalling_mode

8UI

0x00 - CCP2 Data/clock signalling:

0x01 - CCP2 Data/strobe signalling:

0x02 - CSI-2:

This register should not be changed

while the device is streaming data.

VS6663CD 数据表(PDF) 26 Page - STMicroelectronics

VS6663CD 数据表(HTML) 26 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

数据表下载