| 数据搜索系统,热门电子元器件搜索 |
|
STGAP1STR 数据表(PDF) 35 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STGAP1STR 数据表(HTML) 35 Page - STMicroelectronics |
|
35 / 67 page ![]() DocID027190 Rev 3 35/67 STGAP1S Functional description 67 This configuration overrides some drawbacks of using the 2LTO at each turn-off, such as the minimum pulse width equal to t2LTOtime and the turn-on delay needed to avoid duty cycle distortion. With this configuration the turn-off is only slowed down in case of desaturation or overcurrent events. Figure 16. Example of operation with 2LTO in “Fault” mode 7.10.3 Never The 2LTO function is disabled (2LTOtime = 0x0). In this case a standard turn-off sequence is used (directly lowering the gate voltage from VH to VL) also in case of desaturation or sense overcurrent events. 7.11 Failure management The device provides advanced diagnostic through open drain outputs (DIAG1/DIAG2) and internal status registers. The DIAG2 output shares the same pin of the IN- input (see Figure 1 on page 8); the diagnostic signal through the pin is enabled through the DIAG_EN pin as described in Section 7.1 on page 25. Status registers (STATUS1, STATUS2 and STATUS3) provide failures and status information as listed in respective paragraphs. DIAG1 and DIAG2 pins can be programmed through the dedicated registers (DIAG1 and DIAG2) to signal one or more failure conditions. The output value is the result of the NOR of the selected status bits: if one of the selected bits is high, the output is forced low. Some of the failure conditions reported by the status registers are latched, i.e.: the flag is kept high even if the triggering condition is expired. In this case the failure flag can be released in following ways: Using the ResetStatus command (all flags are released) Forcing low the SD pin for at least trelease when the SD_FLAG configuration bit is set high. All the flags are released at the SD rising edge. Using HW reset (see Section 7.3 on page 29). In this case the device behaves as after power-up sequence. In any case, if the failure condition is still present, the respective flag is not released. tDon t2LTOtime tDoff tDESAT INAND GON-GOFF VDESATth DESAT tDoff tDon |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |