STGAP1STR datasheet(51/67 Pages) STMICROELECTRONICS

51 / 67 page

DocID027190 Rev 3

51/67

STGAP1S

Programming manual

The CRC_SPI bit enables the CRC check on the SPI communication protocol.

The UVLOD_EN bit enables the UVLO protection on VDD supply voltage.

The SD_FLAG bit sets the SD pin functionality according to Table 26. When the reset of the

failure flags through the SD pin is enabled, keeping low the SD pin for at least trelease

causes all the latched flags of the status registers to be released at next SD rising edge.

The DIAG_EN bit sets if the IN-/DIAG2 pin works as the input or open drain output

according to Table 27. Refer to Section 7.1 on page 25 for details.

The DTset bits set the deadtime value.

The INfilter bits set the input deglitch time tdeglitch for SD, IN- and IN+ pins.

Table 24. CRC enable

CRC_SPI

SPI communication protocol CRC enable

Disabled

Enabled

Table 25. VDD supply voltage UVLO enable

UVLOD_EN

Supply voltage UVLOD enable

Disabled

Enabled

Table 26. SD pin FAULT management

SD_FLAG

SD pin functionality

SD pin do not reset STATUS registers

SD pin reset STATUS registers

Table 27. IN-/DIAG2 pin functionality

DIAG_EN

IN-/DIAG2 pin functionality

The IN-/DIAG2 pin work as input

The IN-/DIAG2 pin work as open drain output

Table 28. Deadtime

DTset [1 ... 0]

Deadtime value [ns]

Disabled

250

800

1200

STGAP1STR 数据表(PDF) 51 Page - STMicroelectronics

STGAP1STR 数据表(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

数据表下载

链接网址

STGAP1STR 数据表(PDF) 51 Page - STMicroelectronics

STGAP1STR 数据表(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

数据表 下载

链接网址

数据表下载