ENICSF2811PBKA datasheet(149/172 Pages) TI1

149 / 172 page

6.02

1.76)

(SINAD

TMS320F2810, TMS320F2811, TMS320F2812

TMS320C2810, TMS320C2811, TMS320C2812

www.ti.com

SPRS174T – APRIL 2001 – REVISED MAY 2012

6.30.8 Definitions of Specifications and Terminology

Integral Nonlinearity

Integral nonlinearity refers to the deviation of each individual code from a line drawn from zero through full

scale. The point used as zero occurs 1/2 LSB before the first code transition. The full-scale point is

defined as level 1/2 LSB beyond the last code transition. The deviation is measured from the center of

each particular code to the true straight line between these two points.

Differential Nonlinearity

An ideal ADC exhibits code transitions that are exactly 1 LSB apart. DNL is the deviation from this ideal

value. A differential nonlinearity error of less than ±1 LSB ensures no missing codes.

Zero Offset

The major carry transition should occur when the analog input is at zero volt. Zero error is defined as the

deviation of the actual transition from that point.

Gain Error

The first code transition should occur at an analog value 1/2 LSB above negative full scale. The last

transition should occur at an analog value 1 1/2 LSB below the nominal full scale. Gain error is the

deviation of the actual difference between first and last code transitions and the ideal difference between

first and last code transitions.

Signal-to-Noise Ratio + Distortion (SINAD)

SINAD is the ratio of the rms value of the measured input signal to the rms sum of all other spectral

components below the Nyquist frequency, including harmonics but excluding dc. The value for SINAD is

expressed in decibels.

Effective Number of Bits (ENOB)

For a sine wave, SINAD can be expressed in terms of the number of bits. Using the following formula,

it is possible to get a measure of performance expressed as N, the effective number of bits. Thus,

effective number of bits for a device for sine wave inputs at a given input frequency can be calculated

directly from its measured SINAD.

Total Harmonic Distortion (THD)

THD is the ratio of the rms sum of the first six harmonic components to the rms value of the measured

input signal and is expressed as a percentage or in decibels.

Spurious Free Dynamic Range (SFDR)

SFDR is the difference in dB between the rms amplitude of the input signal and the peak spurious signal.

Electrical Specifications

149

Submit Documentation Feedback

Product Folder Link(s): TMS320F2810 TMS320F2811 TMS320F2812 TMS320C2810 TMS320C2811 TMS320C2812

ENICSF2811PBKA 数据表(PDF) 149 Page - Texas Instruments

ENICSF2811PBKA 数据表(HTML) 149 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载