| 数据搜索系统,热门电子元器件搜索 |
|
STM32L162VC 数据表(PDF) 69 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32L162VC 数据表(HTML) 69 Page - STMicroelectronics |
|
69 / 123 page ![]() DocID022881 Rev 10 69/123 STM32L162VC, STM32L162RC 104 For CL1 and CL2, it is recommended to use high-quality external ceramic capacitors in the 5 pF to 25 pF range (typ.), designed for high-frequency applications, and selected to match the requirements of the crystal or resonator (see Figure 14). CL1 and CL2 are usually the same size. The crystal manufacturer typically specifies a load capacitance which is the series combination of CL1 and CL2. PCB and MCU pin capacitance must be included (10 pF can be used as a rough estimate of the combined pin and board capacitance) when sizing CL1 and CL2. Refer to the application note AN2867 “Oscillator design guide for ST microcontrollers” available from the ST website www.st.com. Table 29. HSE oscillator characteristics(1)(2) Symbol Parameter Conditions Min Typ Max Unit fOSC_IN Oscillator frequency - 1 24 MHz RF Feedback resistor - - 200 - k Ω C Recommended load capacitance versus equivalent serial resistance of the crystal (RS)(3) RS = 30 Ω -20 - pF IHSE HSE driving current VDD= 3.3 V, VIN = VSS with 30 pF load -- 3 mA IDD(HSE) HSE oscillator power consumption C = 20 pF fOSC = 16 MHz -- 2.5 (startup) 0.7 (stabilized) mA C = 10 pF fOSC = 16 MHz -- 2.5 (startup) 0.46 (stabilized) gm Oscillator transconductance Startup 3.5 - - mA /V tSU(HSE)(4) Startup time VDD is stabilized - 1 - ms 1. Resonator characteristics given by the crystal/ceramic resonator manufacturer. 2. Guaranteed by characterization results. 3. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a humid environment, due to the induced leakage and the bias condition change. However, it is recommended to take this point into account if the MCU is used in tough humidity conditions. 4. tSU(HSE) is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly with the crystal manufacturer. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |