STM32L162VC datasheet(25/123 Pages) STMICROELECTRONICS

25 / 123 page

DocID022881 Rev 10

25/123

STM32L162VC, STM32L162RC

3.10.1

Temperature sensor

The temperature sensor (TS) generates a voltage VSENSE that varies linearly with

temperature.

The temperature sensor is internally connected to the ADC_IN16 input channel which is

used to convert the sensor output voltage into a digital value.

The sensor provides good linearity but it has to be calibrated to obtain good overall

accuracy of the temperature measurement. As the offset of the temperature sensor varies

from chip to chip due to process variation, the uncalibrated internal temperature sensor is

suitable for applications that detect temperature changes only.

To improve the accuracy of the temperature sensor measurement, each device is

individually factory-calibrated by ST. The temperature sensor factory calibration data are

stored by ST in the system memory area, accessible in read-only mode. See Table 61:

Temperature sensor calibration values.

3.10.2

Internal voltage reference (VREFINT)

The internal voltage reference (VREFINT) provides a stable (bandgap) voltage output for the

ADC and Comparators. VREFINT is internally connected to the ADC_IN17 input channel. It

enables accurate monitoring of the VDD value (when no external voltage, VREF+, is

available for ADC). The precise voltage of VREFINT is individually measured for each part by

ST during production test and stored in the system memory area. It is accessible in read-

only mode. See Table 16: Embedded internal reference voltage calibration values.

3.11

DAC (digital-to-analog converter)

The two 12-bit buffered DAC channels can be used to convert two digital signals into two

analog voltage signal outputs. The chosen design structure is composed of integrated

resistor strings and an amplifier in non-inverting configuration.

This dual digital Interface supports the following features:

•

Two DAC converters: one for each output channel

•

8-bit or 12-bit monotonic output

•

Left or right data alignment in 12-bit mode

•

Synchronized update capability

•

Noise-wave generation

•

Triangular-wave generation

•

Dual DAC channels, independent or simultaneous conversions

•

DMA capability for each channel (including the underrun interrupt)

•

External triggers for conversion

•

Input reference voltage VREF+

Eight DAC trigger inputs are used in the STM32L162xC devices. The DAC channels are

triggered through the timer update outputs that are also connected to different DMA

channels.

STM32L162VC 数据表(PDF) 25 Page - STMicroelectronics

STM32L162VC 数据表(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载