SPC58EEX datasheet(134/154 Pages) STMICROELECTRONICS

134 / 154 page

Package information

SPC58EEx, SPC58NEx

134/154

DS11646 Rev 4

Figure 53. eLQFP176 leadframe pad design

Table 78. eLQFP176 Symbol definitions

Symbol

Definition

Notes

aaa

The tolerance that controls the position of

the terminal pattern with respect to Datum A

and B. The center of the tolerance zone for

each terminal is defined by basic dimension

e as related to Datum A and B.

For flange-molded packages, this tolerance

also applies for basic dimensions D1 and

E1. For packages tooled with intentional

terminal tip protrusions, aaa does not apply

to those protrusions.

bbb

The bilateral profile tolerance that controls

the position of the plastic body sides. The

centers of the profile zones are defined by

the basic dimensions D and E.

—

ccc

The unilateral tolerance located above the

seating plane where in the bottom surface of

all terminals must be located.

This tolerance is commonly know as the

“coplanarity” of the package terminals.

ddd

The tolerance that controls the position of

the terminals to each other. The centers of

the profile zones are defined by basic

dimension e.

This tolerance is normally compounded with

tolerance zone defined by “b”.

Note: number, dimensions and positions of grooves are for reference only.

SPC58EEX 数据表(PDF) 134 Page - STMicroelectronics

SPC58EEX 数据表(HTML) 134 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载