ADP1850ACPZ-R7 datasheet(26/32 Pages) AD

26 / 32 page

ADP1850

Data Sheet

Rev. C | Page 26 of 32

SWITCH NODE

The switch node is the noisiest place in the switcher circuit with

large ac and dc voltages and currents. This node should be wide

to minimize resistive voltage drop. To minimize capacitively

coupled noise, the total area should be small. Place the FETs

and inductor close together on a small copper plane to minimize

series resistance and keep the copper area small.

GATE DRIVER PATHS

Gate drive traces (DH and DL) handle high dI/dt and tend to

produce noise and ringing. They should be as short and direct

as possible. If vias are needed, it is best to use two relatively

large ones in parallel to reduce the peak current density and the

current in each via. If the overall PCB layout is less than

optimal, slowing down the gate drive slightly can be helpful to

reduce noise and ringing. It is occasionally helpful to place

small value resistors, such as between 2 Ω and 4 Ω, on the DHx

and DLx pins. These can be populated with 0 Ω resistors if

resistance is not needed. Note that the added gate resistance

increases the switching rise and fall times, as well as increasing

switching power loss in the MOSFET.

OUTPUT CAPACITORS

The negative terminal of the output filter capacitors should be

tied close to the source of the low side FET. Doing this helps to

minimize voltage differences between AGND and PGNDx.

ADP1850ACPZ-R7 数据表(PDF) 26 Page - Analog Devices